What are common reasons my Mitsubishi Lancer has heater problems?
What are common reasons my Mitsubishi Lancer has heater problems? While there are a variety of reasons your Mitsubishi Lancer heater is not working, the most common 3 are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.
What to do if your AC blower is not working?
Disconnect cables to motor and resistor. Remove hose from motor, it should just pull off with little effort. Unscrew motor and resistor. Screw new motor and resistor in. Connect hose to motor. Connect cables to motor and resistor. Turn on car and test AC. Thanks for watching! Loading…
What should the idle speed be on a Mitsubishi Lancer?
When your car is warm in P, rpm should be around 700-800. If they are higher than this, calibrate them with the throttle body and put them at 700-800 rpm. Open the switch without starting the car so that the idle speed engine is adjusted. By driving for a while at high and low, it will be adjusted.
Where is the IAC valve on a Mitsubishi Lancer?
You need to check both the IAC valve and the computer, as when the first is in a really bad condition, it tends to damage the computer as well. Check the wiring that connects the two of them, which is beneath the glove compartment on the passenger side.
What are common reasons my Mitsubishi Lancer has heater problems? While there are a variety of reasons your Mitsubishi Lancer heater is not working, the most common 3 are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.
How do you wire up a Mitsubishi Lancer stereo?
Upgrading your Mitsubishi Lancer stereo has never been so easy. Simply find the year of your Lancer and match up the wires that you are having difficulty with. This guide is here to help you wire up your Lancer speakers or complete the Lancer radio install. Today I’ll be showing you how to wire up anything in your Mitsubishi Lancer stereo.
Why is my Mitsubishi Lancer making a clicking sound?
The Car drives for a while and later, the lights go dim, the Car begins to Jerk and finally Stalls. Any attempt to start the Engine results the Starter Motor making a Clicking sound. After a couple of Hours, the Car will start, but the same result will repeat itself.
Why is my Mitsubishi Lancer not shifting gears?
Car cannot shift gears by itself or pick up speed on relatively steep ascents. On too steep hills, I normally stop the car at the bottom then accelerate to maintain first gear for vehicle to complete. If not, the car will move very slowly and one feels the engine strain.
How to replace the radio unit on a Mitsubishi Lancer?
Save yourself the labor costs and simply do it yourself following this step-by-step guide. In this guide I will be replacing the radio unit for a 2008 Mitsubishi Lancer. The model and part number of the radio unit may vary with year. The model/part number for the radio unit is: MN141319/DY-3W69U
When does the radio reset on a Mitsubishi?
As part of the radio’s anti-theft system on some older model year vehicles (2002 and older), the radio resets itself whenever it loses power from the vehicle’s battery. Radio security codes are associated with each individual radio unit rather than the vehicle identification number (VIN).
How to remove Black Antenna from Mitsubishi Lancer?
Remove the black antenna connection by simply pulling it out. Remove both the large and small wire harnesses by firmly pressing in and holding the retaining clip. While continuing to hold down the retaining clip, firmly pull the harnesses out. Do not pull harnesses out by the wires, as you may damage or break the wires.