Is your belt tensioner supposed to move?
If there is none, the spring has lost its force. Other indicators are belt squeal from slippage, or loss of rotation of a belt-driven component. It’s normal for it to move a little. A bad belt tensioner spring will often cause the tension arm to bounce up and down with the cycling of the motor.
Is the warrior Idles fine when trying to accelerate?
The warrior idles fine. I’ve adjusted to air mix screw back and forth. It changes the idol but doesn’t seem to improve things when I try to rev it up. 2.25 turns seems to be the sweet spot, as far as idol. The needle is where zoom put it.
Why does my Raptor idle when trying to accelerate?
Sounds like the accelerator pump isn’t working, or pilot is partially plugged, or air mixture is too lean. May be a combo of several of those things. When my sons Raptor was doing that, it was because the pilot was too small, then had to tweak the air mixture to get it just right.
What does it mean when your car Idles but wont accelerate?
The motor turns over and idles fine. The minute I put it into gear, its starts to sputter a little (sometimes it dies). Any time that I give it throttle, it shuts off. As a test, I had someone pull my prime knob on the motor as I was giving it gas, and this worked fine.
Why does my Traxx idle die when trying to accelerate?
The studs are there, but a piece of the ring that the header slides into is broke off. It ran when it pulled it in the shed. The pilot that’s in it now is the one from the carb that was on it.
Can a dirty idle circuit not accelerate under load?
A dirty idle circuit can idle fine and rev like crazy, but bog and die as soon as the throttle is opened while under load. Re: Motor will not accelerate under load. My 150 mercury was doing the same thing and it was the switch box not spark on 3 cyclinders, so for sure check the spark.
The warrior idles fine. I’ve adjusted to air mix screw back and forth. It changes the idol but doesn’t seem to improve things when I try to rev it up. 2.25 turns seems to be the sweet spot, as far as idol. The needle is where zoom put it.
What to do if your bike Idles when trying to accelerate?
Clean the carb,run some sea foam through it,if that doesn’t work,try your timing.if all else fails it could be a sticky valve and or a bent valve ( I ran a bike on a bent valve for 2 months before it blew) How do you check the valves. I’m not a mechanic but I can do the small stuff. Lol I have a 89 warrior. I put it in the shed during deer season.
Sounds like the accelerator pump isn’t working, or pilot is partially plugged, or air mixture is too lean. May be a combo of several of those things. When my sons Raptor was doing that, it was because the pilot was too small, then had to tweak the air mixture to get it just right.