Is there a B1000 trouble code on my car?
GM has issued a TSB #08-09-004 for B1000 SRS light on GM vehicles to correct the false illumination of the airbag light and a corresponding B1000 trouble code. The TSB applies to 2008 Buick Enclave, 2005-08 Cadillac SRX, 2005-08 Chevrolet Equinox, 2007-08 GMC Acadia, 2006-08 Pontiac Torrent, 2007-08 Saturn OUTLOOK, and 2007-08 Suzuki XL-7.
What happens if I get a B1000 DTC and no other?
The Code reader shows only one code, and it’s B1000 which is ECU malfunction 2, according to my code reader. If you try and erase the code it says it is successful, but upon re-link it comes back. I already had myairbags.com reprogram the airbag module and get the same B1000 code.
What’s the only code for a B1000 ECU?
The only code is b1000 ecu malfunction 1. Here is what I had to do. First pull maf or map sensor and get it to throw a engine code then cleared all codes. This took out the check engine light. Replaced the transfer case control module, this restored 4wd operation. Sent airbag into myairbags.com. They sent it back and said it was as good as new.
What is the code for the B1000 airbag light?
GM has issued a TSB #08-09-004 for B1000 SRS light on GM vehicles to correct the false illumination of the airbag light and a corresponding B1000 trouble code. The TSB applies to 2008 Buick Enclave, 2005-08 Cadillac SRX, 2005-08 Chevrolet Equinox, 2007-08 GMC Acadia, 2006-08 Pontiac Torrent,
GM has issued a TSB #08-09-004 for B1000 SRS light on GM vehicles to correct the false illumination of the airbag light and a corresponding B1000 trouble code. The TSB applies to 2008 Buick Enclave, 2005-08 Cadillac SRX, 2005-08 Chevrolet Equinox, 2007-08 GMC Acadia, 2006-08 Pontiac Torrent, 2007-08 Saturn OUTLOOK, and 2007-08 Suzuki XL-7.
How much does it cost to diagnose a B1000 code?
The cost to diagnose the B1000 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. How much do you know about cars?
The Code reader shows only one code, and it’s B1000 which is ECU malfunction 2, according to my code reader. If you try and erase the code it says it is successful, but upon re-link it comes back. I already had myairbags.com reprogram the airbag module and get the same B1000 code.
The only code is b1000 ecu malfunction 1. Here is what I had to do. First pull maf or map sensor and get it to throw a engine code then cleared all codes. This took out the check engine light. Replaced the transfer case control module, this restored 4wd operation. Sent airbag into myairbags.com. They sent it back and said it was as good as new.