Is the fuel gauge off on a Nissan Quest?
In May 2014, the National Highway Traffic Safety Administration (NHTSA) opened an investigation after receiving 140 complaints from 2007 Quest owners. According to those complaints, the gauge could be off by as many as 60-80 miles, especially when the tank was less than 1/4 full.
What can a Nissan Quest mass air flow sensor do?
A defective Nissan Quest mass airflow sensor could make your car difficult to start. Your ECU uses the mass airflow sensor input to determine the fuel ratio that the injectors need to deliver to the engine. If your check engine light is still on, use an OBD2 scanner to clear any stored codes in the ECU.
When do you reset the fuel cut off switch?
After speeding over a deep pothole, speed bumper, or after a car accident, you could end up with an engine unable to start. In most cases, you only need to reset the fuel cut off switch, which was activated by the impact. It looks simple, right?
How do you reset the fuel gauge on a car?
If this happens, reset your fuel gauge. Each make and model of car has its own specific instructions on how to reset the fuel gauge, but the process is basically the same. Turn the ignition switch to the “On” position. Press the “Odo/Trip” button until the odometer is put into “ODO” mode. Turn off the ignition.
Where is the reset button on a fuel pump?
Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case. You may need to turn the ignition key to the on or accessory position to energize the module and reset the switch.
How can I reset the fuel cut off?
This is similar to an electrical circuit breaker in your home which can be easily reset by pushing the button or pulling the leverage down. All modern fuel injection cars are equipped with an inertial fuel cut off switch that shuts off the power supply for the fuel pump if the vehicle is in a collision.
If this happens, reset your fuel gauge. Each make and model of car has its own specific instructions on how to reset the fuel gauge, but the process is basically the same. Turn the ignition switch to the “On” position. Press the “Odo/Trip” button until the odometer is put into “ODO” mode. Turn off the ignition.
Where is the fuel pump shut off switch?
Average rating from 198 customers who received a Car is stalling Inspection. The fuel pump shut off switch is an electrical switch that is found on certain vehicles equipped with internal combustion engines.