Is it worth replacing power steering and alternator belt?
Its not worth the inconvenience of a broken belt, and if you are unlucky one of them drives the water pump so you could end up killing your engine in the process.. Garage would probably charge an hours labour + belts to do both. So looking at say £40-60 inc parts.
How do you remove a power steering belt?
Slacken the adjuster and pivot bolts, and push the pump inwards by the cast front plate until the belt is slack enough to ease off. Do not push against any other part of the pump or pipework, or you may damage it. Remove the old belt. If it is the outermost of several belts on the engine, removal is straightforward.
Which is the correct belt length for power steering?
Yes 728 is the length, but 725 is as standard, so you have the right belt. Loosen power-steering pulley nut from the top, loosen the two lower power-steering mounting bolts at the hinge point underneath, then slacken off the adjuster]
What to do if your power steering belt is too slack?
If the belt was too slack, increase the tension by levering the pump outwards with a strong screwdriver or flat bar. Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged.
How do you replace a power steering belt?
Use a 13mm socket to loosen, but not remove, the bolt on the power steering pump tensioner bracket. Place a 19mm wrench over the nut on the front of the power steering pump tensioner, then place a 13mm socket over the lock nut. Holding the 19mm wrench, loosen the lock nut, then then turn the tensioner nut to release the tension on the belt.
What’s the difference between an alternator and a power steering belt?
The alternator belt uses a pinch bolt and a long tension bolt, in addition to its pivot bolt. The power steering bolt has a tension bolt and a pinch bolt that slides on a track. Tensioning the power steering belt can be difficult since the position of the pump, determined by the position if your pry bar, determines the tension.
Can a car be driven without an alternator belt?
You can drive your car without either of those belts. However, you won’t get very far without the belt that turns your alternator. If the alternator isn’t operating, while the car is running, all this juice comes from the battery. As the battery dies, the components start losing power. Also Know, does a faulty alternator affect power steering?
Where does the energy from the alternator belt go?
The alternator belt connects your alternator, power steering pump, air conditioning compressor, and water pump to your battery; it transports energy from the engine towards the alternator, which in turn powers the battery.