Is installing a short shifter hard?
With a short throw shifter, driving your car will be more enjoyable experience. In the rest of this post, we’ll teach you how to install a short throw shifter. It can be quite challenging, but once you know the right steps, it will be a lot easier. Be patient as this can take quite a while.
How do you remove a shifter from a Honda Civic?
Remove the center consonle. To remove the shifter stick, you will have to go under the car to the shift stick linkage. Using a 12mm socket and ratchet, remove the bolt at the base of the shifter. You may have to secure the other end of the bolt with another 12mm wrench or a vise grip to hold the nut.
How do you put a new shifter on a Honda Accord?
Careful slide the dust cover and gasket up on the new shifter to seat it securely over the pivot ball. Put the metal plate back over the bottom of the shifter, and seat it onto the bottom of the dust cover. Put the shifter back up through the holding plate on the shifter rod, and quickly re-install the two bolts to hold the entire shifter assembly.
How do you install a new transmission shifter?
The new shifter bushing with the original bearings pressed in. Re-install the completed rod under the car. First, place the end with new bushings in the bracket behind the transmission with the 12mm wrench. Slide the top of the new shifter up through the floor pan and into the console area.
Is there an adapter for the 8th Gen civic?
The 8th gen Civic uses a unique shifter setup as compared to the shifters used by almost every other cable shifter equipped Honda. Until recently, there hasn’t been a great deal of aftermarket support. The most common upgrade is the shifter adapter. I wasn’t looking for an aggressive improvement but I did want to tighten up the shift.
What should I use to replace the shifter on my Honda Civic?
Consider using lithium grease, a comparable rubber, or bearing grease on the bushings to help it slide into place more easily. Reattach the remaining rod to the bottom of the shifter. Make sure all bolts are secure. Replace the rubber gasket, the boot, and console over the top end of the new shifter stick.
Careful slide the dust cover and gasket up on the new shifter to seat it securely over the pivot ball. Put the metal plate back over the bottom of the shifter, and seat it onto the bottom of the dust cover. Put the shifter back up through the holding plate on the shifter rod, and quickly re-install the two bolts to hold the entire shifter assembly.
The new shifter bushing with the original bearings pressed in. Re-install the completed rod under the car. First, place the end with new bushings in the bracket behind the transmission with the 12mm wrench. Slide the top of the new shifter up through the floor pan and into the console area.
How do you jack up a Honda Civic?
(Related Article: How to Jack Up Your Civic – Honda-Tech.com) Unscrew and remove the shifter knob. Remove the six screws securing the center console. Remove the portion of the console surrounding the shifter. Remove the rubber seal around the base of the shifter. Figure 2. Remove the center consonle.