How to replace shocks and springs in a car?
Remove brake line from its holding bracket , Remove nut from bottom of the strut 22mm nut and large shifter on bolt head but leave the bolt in for now , Then remove nut from the upper ball joint 18mm nut 6.
How do you replace a suspension spring on a riding mower?
You’ll first remove the bottom bolt attached to the lower control arm, then remove the top two or three bolts attached to the upper body mount. Remove the old strut or shock and replace it with the new one. Step 8: Install the new suspension spring.
How do you remove a spring from a car?
The top of the spring may be stuck to the upper body mount, but wiggling the spring once it is loose should clear that obstacle. Move the lower control arm down until the spring is completely loose. Remove the spring from the vehicle. Step 7: Remove the old strut or shock.
What’s the best way to replace a shock absorber?
Consult your owner’s manual to find out for sure. Use the same process to remove the nut that is positioned at the top and keep the nuts separate so you will know which one goes where when it is time to install your new shocks. Remove the shock absorber from the bottom and top bolts.
What’s the best way to replace a suspension spring?
Move the lower control arm down until the spring is completely loose. Remove the spring from the vehicle. Step 7: Remove the old strut or shock. Since you’re replacing the spring, it’s a good idea to replace the strut or shock at the same time. Although this step is not required, it’s recommended by most manufacturers and ASE certified mechanics.
How to replace your own shocks and struts?
How to replace shocks and struts 1. Check whether you need a spring compressor. On many cars, the struts/shocks and springs are interrelated or… 2. Securely raise one side of the car. If you’ve got access to an actual lift, great. Driveway DIYers everywhere are… 3. Remove the wheel and extract
Consult your owner’s manual to find out for sure. Use the same process to remove the nut that is positioned at the top and keep the nuts separate so you will know which one goes where when it is time to install your new shocks. Remove the shock absorber from the bottom and top bolts.
How do you replace coil springs on a car?
Then use the pickle fork between the control arm and the spindle. This will separate the friction fit between the two. You will then have to jack up the rotor to remove the control arm from the spindle stud. Open the hood and locate the three mounting bolts that hold the strut into the body.