How to replace rear wheel bearing hub assembly?
Screw the two M8×1.25 bolts into the holes in the drum brake to push it away from the hub. It may be rusted to the hub so prepare for some cracking sounds. Remove the drum once it is free 8. Remove the four 12mm bolts on the back of the hub.
What kind of bolts do you need to replace wheel bearings?
Thus replacing wheel bearings when they are worn are imperative to maintaining a safe vehicle. Four bolts hold the rear hub assembly to the rear knuckle. However, the caliper, caliper bracket, pads and rotor need to be removed to remove the hub from the knuckle, all of which use 14mm bolts in this application.
How much does it cost to replace rear wheel bearing assembly?
This easy DIY is to replace the entire REAR hub bearing assembly and takes about 50 minutes. – the OEM Toyota rear hub bearing assembly WITH ABS is much cheaper ($135) than the one without ABS ($260) and still fits cars without ABS. Other brands start at around $90. – 2 M8×1.25 bolts.
How do you replace a Colorado wheel bearing?
When the wheel hub is ¾’s of the way out, having the ability to smack the back of the hub with the rotor is usually just enough force to break it free. On one wheel the hub needed a few taps from the brake rotor to assist the hub out of the spindle, on the other wheel bearing I did not.
Thus replacing wheel bearings when they are worn are imperative to maintaining a safe vehicle. Four bolts hold the rear hub assembly to the rear knuckle. However, the caliper, caliper bracket, pads and rotor need to be removed to remove the hub from the knuckle, all of which use 14mm bolts in this application.
How to remove Rusted Wheel hub bearing assembly the easy way?
How to remove a rusted wheel hub bearing assembly the easy way. – YouTube How to remove a rusted wheel hub bearing assembly the easy way. If playback doesn’t begin shortly, try restarting your device.
Where are hub assemblies and wheel bearings located?
Why you should maintain hub assemblies and wheel bearings. Located between the brake drums/discs and the drive axle, the hub assembly is mounted to the holding bracket of the chassis on the axle side. On the drum/disc side, the wheel is connected to the hub assembly via bolts. The wheel bearing itself is inside the hub unit.
How to replace the rear hub bearing on a Ford Explorer?
Loosen the lug nuts from the wheel which the bearing is going to be replaced. Step 2: Raise and secure the vehicle. Raise the vehicle and secure it on jack stands, and then remove the wheel. Place blocks of wood underneath the front and rear of the wheel diagonally opposed from the one you will be working on.