How to replace fuel pump in 2003 Chevy?
Unbolt and remove the fuel tank’s shield with a wrench and then disconnect the ground strap on the filler pipe. Disconnect the EVAP canister lines at its quick connect fittings and then unbolt and remove the canister from its bracket using a wrench. Disconnect the lines and electrical connectors from the fuel pump module’s flange on the tank.
How to change a broken fuel pump without dropping the gas tank?
TheCousinDan shows you how to change a broken fuel pump without dropping the gas tank. This time it’s done by actually cutting a hole in your car (don’t worry, it’s not as bad as it sounds). Music: NCS Def Kev
How do you remove a fuel pump on a Harley?
Harley fuel pump and filter removal is a project you can do with ease. Bob LaRosa and Mark DiPietro take the time to cover all painted areas, drain fuel from the system and use the right tool to remove the pump and filter from the tank. JIMS Tools available at DennisKirk.com – See the JIMS Fuel Pump Retainer Remover Tool on DennisKirk.com.
Can a vacuum pump be used to replace a fuel pump?
This pump can wear out if you constantly drive your truck with the fuel level low. You need the fuel to be low, however, if you are going to replace the module. Siphon out as much fuel as possible with a proper vacuum pump kit if needed; never siphon out by mouth.
Unbolt and remove the fuel tank’s shield with a wrench and then disconnect the ground strap on the filler pipe. Disconnect the EVAP canister lines at its quick connect fittings and then unbolt and remove the canister from its bracket using a wrench. Disconnect the lines and electrical connectors from the fuel pump module’s flange on the tank.
How do you remove the pump from a gas tank?
Unplug the electrical connector and wipe off the pipes and assembly to prevent buildup from getting into the fuel. Snap open the quick-connect fittings and remove the hoses. Pry off the snap ring that retains the pump and slide the pump assembly out of the tank.
Where is the fuel pump on a 2003 Chevy Impala?
The fuel pump in your 2003 Chevrolet Impala is easy to access. Unlike on many vehicles, you will not have to remove the fuel tank or jack up the car. All of the connections are designed to be separated by hand, so you only need tools to remove an access panel.
How do you remove the fuel pump access panel?
Remove the spare tire and trunk liner to reveal the fuel pump access panel. Remove the seven nuts that hold it in place and pull off the panel. Unplug the electrical connector and wipe off the pipes and assembly to prevent buildup from getting into the fuel. Snap open the quick-connect fittings and remove the hoses.
Where is the fuel pump relay on a Pontiac Grand Am?
The fuel pump relay is #18 in the fuse box. Start with the car off, and have somebody else put the key in the cars ignition and attempt to start the car while you listen to the relay. If you can hear this relay make a “clicking” noise as the car attempts to start, then it is working properly.
Why is my fuel pump reset button not working?
Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc. As a first step best to see if there are any stored trouble codes that could point directly to the fault.