How to remove the condenser from a radiator?
Step 3 Disconnect the bolts on the sides of the radiator bracket, supporting the radiator’s weight with a jack or axle stands underneath it. Step 4 Remove the condenser’s upper mounting bolts, which are near those upper radiator bolts, and then unclip the condenser and remove it from underneath.
How do you remove a sealed air conditioner?
Remove Sealed Unit – Once you can see the inside of the air conditioner, you should see a few things including one or two radiators, a sealed unit, an electric motor, a power supply, and some copper tubing. Grab your wrench and begin disconnecting the sealed unit from the base of the unit.
How long does it take to replace an aircon radiator?
2.the condenser has various filters inside it that need replaced and are notoriously difficult to get 3.when replaced the whole system needs to be flushed with a special soloution to remove any contaminents and moisture if this isnt done the compressor will fail within a few months and youll be looking at easily a 500 quid bill
How do you remove an air conditioner motor?
Remove Electric Motor – Towards the back of the air conditioner, you should see a fan and electric motor attached that can be removed. The fan will either be plastic or steel, so put it in the correct pile. Use your screwdriver to detach the electric copper motor from the fan and put that in a separate pile. It will probably weigh about 5 pounds.
Remove Sealed Unit – Once you can see the inside of the air conditioner, you should see a few things including one or two radiators, a sealed unit, an electric motor, a power supply, and some copper tubing. Grab your wrench and begin disconnecting the sealed unit from the base of the unit.
How do you get air out of the radiator?
For years I have struggled to find a way to get the air out of the system especially when the radiator is lower than some parts of the engine. I found this funnel device that brings the coolant higher than the highest point of the engine. I usually run the car for about 15 minutes and watch the air bleed out of the system.
Remove Electric Motor – Towards the back of the air conditioner, you should see a fan and electric motor attached that can be removed. The fan will either be plastic or steel, so put it in the correct pile. Use your screwdriver to detach the electric copper motor from the fan and put that in a separate pile. It will probably weigh about 5 pounds.
What kind of radiator do you use for AC?
Aluminum/Copper Radiators – Also known as ACR’s, the radiators are the bread and butter of the air conditioner. You will usually see a smaller one in the front and a larger one towards the back. When you first remove these, place them in a vice, and use your sawzall to cut the copper loops off the ends.