How to remove rusted stuck control arm ball joint?
Using metal cutting saw and 800 lb/ft impact gun I was able to remove the lower control arm ball joint that was extremely rusted and stuck hard. It seemed impossible to remove. This is just another alternative method to help you to remove ball joints that are rusted and stuck hard… Thank you for watching! Good luck! Loading…
How do you install a new control arm?
1. Compare the new control arm to the old control arm to be sure both are the same design. 2. Install the new control arm into the mounting bracket in the frame. 3. Reinstall the bolts that secure the control arm to the frame. Do not tighten the bolts down all the way at this time; you will torque them to specification later.
How do you replace a steering knuckle on a car?
Strike the steering knuckle near the ball joint with a large hammer. The ball joint’s stud should eventually pop out if the knuckle is hit hard enough. You can also use a ball joint separator to separate the ball joint from the knuckle. But be forewarned: most separators don’t fit all vehicles.
What’s the best way to repair a front control arm?
Repair manuals, such as those from Chilton, are useful but an ALLDATA subscription is even better. ALLDATA has single-vehicle subscriptions for DIYers that provide detailed factory repair information. Warning: In some instances, the vehicle’s suspension spring must be compressed before removing the control arm.
How do you replace lower control arm joint?
With tension now removed from the torsion bar, loosen the 24mm nut at the bottom of the wheel knuckle that holds the lower control arm ball joint in place. Don’t remove the nut, but leave a large gap between the nut and the wheel knuckle. Figure 6.
Where to remove lower control arm nut on Chevy Silverado?
Remove the already-loosened 24mm nut at the bottom of the wheel knuckle. This nut holds the lower control arm ball joint to the knuckle via its threaded stud. With the jack still in place, remove the 35mm wheel nut and the washer behind it from the center of the hub.
How to remove rusted rusted stuck lower control arm bolts?
You want more loosen, less tighten. spray in between. IF THIS IS WORKING THEN SKIP HEAT, IF NO LUCK then hammer spray, impact heat. do this a few times until bolt starts moving. PATIENCE IS KEY. 9)Thats it. It will backout. If you break the bolt using this method, the bolt was too far gone, and there was nothing
How to replace the lower wheel knuckle on a Chevy Silverado?
Lift lower control arm to free the knuckle from the ball joint’s threaded stud. While lifting up the wheel knuckle, lower the jack, and then pull the wheel knuckle out and away from the lower control arm. Figure 21. Pull away detached wheel knuckle from the lower control arm.