How to remove flywheel bolts on a Mercedes?
There it is written that for removing the flywheel bolts is needed socket with catalogue number 904589001000 . Because this is a Mercedes engine, you can get the special tool either through Mercedes dealer or on the site i have posted earlier. Regards, Stan Ask Your Own Mercedes Question Customerreply replied 10 years ago
How do you remove a flywheel from a motor?
Flywheel Removal On opposite sides of the bolt circle, insert a clutch bolt into each of two threaded clutch bolt holes. Using the two bolts as handles, dislodge the flywheel from the crankshaft flange and remove it from the flywheel housing. After removing the flywheel, remove the bolts from the clutch bolt holes.
How to install engine barring tool on MBE flywheel?
Install the engine barring tool J-46392 in the flywheel housing and secure with two bolts. Insert the locating pin and make sure the tool gears do not rotate. Refer to “1.13.1 Engine Barring Tool Installation” . Lightly oil the threads on eight M14 x 1.5 multipoint socket-head bolts.
When to replace the bolts on a flywheel?
Replace the bolts if any of the shanks are stretched beyond the maximum length of 61.0 mm (2.40 in.). Thoroughly clean the flywheel and check the clutch surface for cracks, burned spots, or scoring. Using an accurate straightedge and a feeler gauge, check the friction (clutch) surface for evenness.
There it is written that for removing the flywheel bolts is needed socket with catalogue number 904589001000 . Because this is a Mercedes engine, you can get the special tool either through Mercedes dealer or on the site i have posted earlier. Regards, Stan Ask Your Own Mercedes Question Customerreply replied 10 years ago
What kind of tool to remove oil filter on Mercedes Benz?
Well removing the filter is easier than it is on a Honda or a Toyota if you have the oil filter housing removal tool. This tool makes removing the oil filter easier than it is to make a bowl of cereal in the morning. Instead of using hexagonal bolt head, Mercedes-Benz uses female Torx star head for optimum torque transfer.
Can you remove the radio from a Mercedes Benz?
That’s only if you have the correct radio removal tool for Mercedes-Benz. If you don’t have these tools, you could end up damaging the dashboard trying to remove the cluster or radio. This tool is frequently used on the radio, but in some Mercedes-Benz models, it is used to remove the instrument cluster as well.
How big are the bolts on a flywheel?
The flywheel bolts are stretch to yield and mounting the flywheel calls for 30-40 Nm of initial torque and then a full 90-100° turn of the bolts. This is a tremendous amount torque. Replacing them is best and recommended. But you can reuse the bolts if they measure more then 7.3 mm diameter at the neck.