How to put a hose on a hose reel?
Start removing the old garden hose from the reel and you will be able to see the water coupling on the drum after the hose is taken out. You will have to uncouple this coupling and you might need a plier for this. Step 3: Now, take the new garden hose and spread it on the ground and attach the female end of the new hose to the drum.
How do you put a hose in a socket?
Insert the cut braided hose into the socket using a twisting and pushing motion until the hose reaches the back of the threads inside the socket nut. There are a range of tools available that help to guide the hose into the socket.
How do you put in braided hose fittings?
There is no need for any significant force to be used. Apply oil to the threads and nipple of the hose end. Carefully insert the hose end nipple into the socket and hose until the socket engages with the hose end threads. Keep everything square to avoid cross threading. Hold the hose to stop it from being pushed out of the socket.
How do you mark the position of a hose fitting?
Mark the position of the hose against the back of the socket nut. Wrap a piece of masking tape around the hose where it meets the back of the socket. This will act as a marker to check if the hose is being pushed out during assembly. We find it useful to apply a small amount of oil to the inside of the hose and the threads of the socket nut.
How to install braided hose fittings step by step?
How To Install Braided Hose Fittings – Step by Step Guide. 1 Step 1. When cutting the braided hose to length first wrap some masking tape around the hose where the cut will take place. This serves to allow a 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
How do you fit a hose into a socket?
Care and attention when cutting the hose will make fitting the hose into the socket a lot easier. Mark the position of the hose against the back of the socket nut. Wrap a piece of masking tape around the hose where it meets the back of the socket.
Mark the position of the hose against the back of the socket nut. Wrap a piece of masking tape around the hose where it meets the back of the socket. This will act as a marker to check if the hose is being pushed out during assembly. We find it useful to apply a small amount of oil to the inside of the hose and the threads of the socket nut.