How to install front fender on Pontiac Firebird?
Step 1: Install Front Fender. Place the fender slightly forward of the wheel and slide it rearward until the rear part is resting on the cowl. Be careful not to hit the windshield or it may crack. If necessary, gently pull out the lower rear portion of the fender to clear the cowl. Step 2: Install Front Fender (CONTINUED)
How do you remove bolts from a Pontiac Firebird?
A ratchet and socket are typically used to remove the bolts and the small straps that hold the U-joint to the yoke. If the bolts are particularly stubborn, use a breaker bar or an impact wrench. Once the bolts have been removed, place a pry bar between the yoke and driveshaft.
How to install bodywork on a Pontiac Firebird?
Make sure the regulator teeth are in good shape and that the arms move up and down easily. The front and rear vertical guides control the up and down motion of the glass. Use a ratchet and socket to install these guides. Two 7/16-inch bolts on top and one 7/16-inch bolt on the bottom hold the glass in place on each side.
Where are the guide stops on a Pontiac Firebird?
Install the guide stops at the top of each vertical guide. A single 7/16-inch bolt attaches these stops to the doorframe. Their function is to prevent the glass from going too far up. While you still have the glass in the lowest position, install the outer door glass weatherstrip, otherwise known as a belt weatherstrip.
How do you remove the rotor on a Pontiac Firebird?
Slide the rotor out slightly to remove the keyed washer and outer bearing. You need to remove the bearing and grease seal from the rotor. To do this, reinstall the spindle nut and turn it clockwise a few threads. Grab the rotor with your hands placed at the three and nine o’clock positions.
How do you replace a wheel bearing on a Pontiac Firebird?
Install a new wheel bearing after packing grease into the bearing orifices. Use a ball-peen or other suitable hammer to gently tap the new grease seal into position on the back side of the rotor. Inspect the rotor and make sure the rotor is true and there is no damage or flaws. Slide it onto hub.
How do you change the brake system on a Firebird?
The braking system of the second-generation Firebird is very good and is relatively inexpensive to replace. Use a lug wrench or breaker bar and socket to remove the lug nuts from the front wheel that is receiving brake service. I advise breaking the torque on the lug nuts before jacking up the car. Use a breaker bar and socket.
How to replace power window on Camaro Firebird?
Disconnect the electrical connection on the back of the panel by twisting it and pulling it out. Remove the two screws located underneath the arm rest and the one located down in the door pocket. Remove the Phillips screw just below the door handle. Remove the screw from the side mirror and pull the cover off.