How to install a new steering rack in a Honda CRV?
If you need to install a new steering rack, you need to exercise extra care to avoid damaging the air bag wiring during the process. Center and lock the steering wheel. Make sure it doesn’t turn while the rack and pinion gear is disconnected. Disconnect the negative battery cable, air bag and steering wheel.
How do you remove a rack and pinion steering rod?
From the underside, you need to unfasten the steering joint bolts, disconnect the tie rod ends and steering hoses, and then remove the left side flange bolts and rack and pinion mounting brackets. Lower the rack and pinion unit to point the pinion shaft outward.
How big is the flare nut on a Honda CRV?
Connect the supply line and tighten the flare nut to 27 foot pounds of torque. Tighten the nuts on tie rod ball stud to 32 foot pounds of torque and the steering joint bolts to 21 foot pounds of torque.
When did Honda second generation steering rack come out?
The second generation, produced from 2002 until 2006, was rated best small SUV by “Car and Driver” magazine following its first release. If you need to install a new steering rack, you need to exercise extra care to avoid damaging the air bag wiring during the process.
If you need to install a new steering rack, you need to exercise extra care to avoid damaging the air bag wiring during the process. Center and lock the steering wheel. Make sure it doesn’t turn while the rack and pinion gear is disconnected. Disconnect the negative battery cable, air bag and steering wheel.
From the underside, you need to unfasten the steering joint bolts, disconnect the tie rod ends and steering hoses, and then remove the left side flange bolts and rack and pinion mounting brackets. Lower the rack and pinion unit to point the pinion shaft outward.
Connect the supply line and tighten the flare nut to 27 foot pounds of torque. Tighten the nuts on tie rod ball stud to 32 foot pounds of torque and the steering joint bolts to 21 foot pounds of torque.
The second generation, produced from 2002 until 2006, was rated best small SUV by “Car and Driver” magazine following its first release. If you need to install a new steering rack, you need to exercise extra care to avoid damaging the air bag wiring during the process.
Do you need to replace rack and pinion?
Most rack and pinion leaks will require the replacement of the entire rack and pinion assembly even if most of it works just fine. The good news is you do have another alternative to an expensive replacement.
Where does the steering column go in rack and pinion?
There is a seal where your steering column enters the rack and pinion assembly, then a seal where each tie rod attaches. Each of these seals have to keep high-pressure power steering fluid contained while allowing the steering column to rotate and the tie rods to move as well.