How to disconnect 4 wheel drive Jeep Wrangler?
Locate the four nozzles on the vacuum switch that control your front disconnect system for your 4wheel drive. (Located on top of your transfer case) Locate the red line (constant source) coming from the transfer case and connect it to the original red hose running behind your air cleaner.
Why is my 4wheel driveguide not working on my Jeep Wrangler?
Remove the switch connection which has a vacuum harness with 4 ports that plug directly into the top of it. (The switch is keyed so it can only fit one way.) Next, unscrew the switch from the TC and inspect. Inspect the ball bearing plunger at the bottom of the switch. This gets jammed inside the switch.
Why is the vacuum switch on my Jeep Wrangler not working?
Inspect the ball bearing plunger at the bottom of the switch. This gets jammed inside the switch. Try and give it a few bangs to release the jammed ball-bearing inside the switch. If that is unsuccessful, you can purchase a new vacuum switch here. Screw in the new switch and reconnected the vacuum harness to the top of it.
Where is the 4WD plug on a Jeep Wrangler?
Plug located vertically on top. (Soft Black Hose) Connects to the plug on your firewall located at the battery. This is for the 4wd indicator on the dashboard. (Green Hose) Goes to the shift motor on the front axle. Horizontal on the shift motor.
How do you remove universal joints from a car?
Remove the bolts at the rear of the driveshaft. The driveshaft connects to the car with 4 bolts on its rear. Use a socket wrench to unscrew each bolt by turning them counterclockwise. Keep the bolts in a safe place so you can reinstall them later.
How to replace a strut on a jeep?
If you’re just replacing struts, then undo the upper ball joint, sway end-links, upper strut mount bolts (4) and drop everything. Loosen the lower strut-clamp bolt and replace the strut, obviously need a spring compressor. You should be good!
What to do when your 4 wheel drive Jerks?
The easiest way to fix bind-up is by pulling over to the side of the road with two wheels firmly on the bitumen and the other 2 wheels on a slippery surface like grass, mud or sand. This allows the wheels to all spin at different speeds releasing the wind-up in the transmission box.
Can a 4WD truck drive without a front drive shaft?
Can you drive a 4WD truck without a front or rear drive shaft? Yes, this is possible if you drive a traditional 4WD with a lockable center differential. Remove the damaged drive shaft and lock the center differential. This will allow the transfer box to transfer power to the front or rear drive shaft.