How to cool down a Mack truck engine?
If the engine is running, the starter temperature is too high, the transmission is not in neutral or the clutch pedal is not depressed, starter engagement is inhibited. Allow the engine to slow down and idle for 3 to 5 minutes before shutting it off. This allows the turbocharger to cool down and the cooling system to dissipate the engine heat.
Where can I buy a Mack dump truck?
***Located In Dayton Ohio*** 2000 Mack CL700 7 Axles, 4 lift axles, 23′ Steel Dump Bed, 8LL Spd Transmission, Nation Wide Delivery Available 400HP]
How long to crank engine in Mack truck?
CAUTION DO NOT crank the engine for more than 30 seconds at a time; wait 15 minutes after each try to allow the starter to cool. Failure to follow these instructions could cause starter damage. Note: Some starters are equipped with starter protection.
What are the body builder instructions for a Mack truck?
Mack Body Builder Instructions PI / CHU, AN / CXU, GR / GU, TD, LR, TE / MRU USA153998270 Date 12
What kind of air temperature sensor does Mack truck use?
CAUTION MACK is now using the ambient air temperature (AAT) sensor for on board diagnostic (on-board diagnostics) monitoring.
What kind of engine does a Mack truck have?
Mack Trucks Body Builder; Engine, MP7, MP8, and MP10 PI / CHU, AN / CXU, GR / GU, TD LR, TE / MRU Section 2 Introduction This information provides details for the MP7, MP8, and MP10 engines for MACK vehicles. Note: We have attempted to cover as much information as possible.
What kind of FMI does a 2012 Mack truck have?
Hi , I have a 2012 Mack with an MP7 . It has an SPN 5246 FMI 0 codes and the truck is on de-rate . Mechanic’s Assistant: Sometimes things that you think will be really complicated end up being easy to fix. The Heavy Truck Mechanic I’m going to connect you with knows all the tricks and shortcuts.