How to check engine light on Polaris quad?

Quad in neutral, turn the key on and off 3 times quick, let it stay in the on position on the 3rd time and it should flash the engine light to give you the code. 5 flashes =5, ect. all codes are 2 digit numbers.

What to do if your Polaris Ranger won’t start?

Pull the fuel line and crank the engine to see if it’s getting gas. Check the fuel filter for a possible clog if this is the case. Also, make sure the fuel tank has gas. Look at the air filter of your Polaris Ranger. It may have a clog in it, which chokes your engine and won’t allow it to run.

How to reset the Check Engine light on a Polaris RZR?

This will drain the capacitors and anything else in your ECU that holds a charge, and is a guaranteed method of resetting your Polaris RZR’s check engine light. With your idiot light situation resolved, you can ride with confidence knowing you’re just as mechanically intelligent as the next person.

When does the Check Engine light go out?

Stop, shut off the engine, start the engine and the code is gone, not in limp mode…and in about a quarter of a mile the check engine light will go out. Polaris set the misfire way to sensitive…and you’re experiencing what a lot of are. There is a solution…Gilomen Innovations has done reprogramming to eliminate the over sensitivity.

What to do if your Polaris loses power?

Thanks for the add! Went riding one day and playing in the mud and water I slipped my belt a little bit. Let it dry and continued on my way. Got home and pressure washed everything and let dry.

Why does my Polaris go sluggish at high speeds?

Did not accelerate fast either. Continued riding and eventually (20 min or so) the **** thing wouldn’t go 15mph or so pedal to the floor in low or high it would go about 30. I could shut it off and turn it back on and it would act half way decent for a few seconds then back to sluggish. No engine light, seat belt plugged in. What could it be?

What does the EPs light on Polaris Sportsman mean?

Illuminates when a fault has occurred in the EPS system. Your authorized Polaris Dealer can assist. EPS operation is possible with key on/engine off for up to 5 minutes. This lamp illuminates to indicate an overheated engine. If the indicator flashes, a severe overheating condition exists.

How to start a Polaris 550 electric car?

Install the cable (PN 4013289), with the part number label opposite of the starter, to the starter motor terminal using spring washer (PN 7552801) and hex nut (PN 7542105). Torque to 8 ft. lbs. (10 Nm). Install the protective cap. Install the rear plated starter bracket (PN 5257395) to the starter using the hex flange nuts (PN 7542153).

How does the service indicator work on a Polaris Sportsman?

On the Service Indicator (5), a flashing wrench symbol alerts the operator that the preset service interval has been reached. Your Polaris Dealer can provide provide scheduled maintenance. For more information, see the Periodic Maintenance Chart section of your Owner’s Manual . The Clock (6) displays time in a 12-hour or 24-hour format.

Thanks for the add! Went riding one day and playing in the mud and water I slipped my belt a little bit. Let it dry and continued on my way. Got home and pressure washed everything and let dry.

Why does my Polaris have a low fuel gauge?

Went riding one day and playing in the mud and water I slipped my belt a little bit. Let it dry and continued on my way. Got home and pressure washed everything and let dry. Went to park it and fuel gauge was flashing low fuel.

What does check engine light under Full Throttle mean?

Moving along quick, about 1/2 or 3/4 throttle and then if I put the pedal right to the floor check engine light comes on and bike goes into a limp mode. No power but still running. Pull over, turn machine off and wait a few minutes, re-start and runs good.

What happens after idle when you give it throttle?

I found a local guy with a parts RZR , took all the electronic componenents and changed them and still the same thing. It is a 2008 model it would start and idle but that is all it will do. Ok what happend after idle? Need more discription of your problem. The simple thought is the TPS slipped. We need more information.

How much does it cost to change Polaris ECU?

Looks like Gilomen’s website now says $220 but with free shipping (I paid for mine) so guessing the $20 covers the flat rate shipping back to you. Anyway point is reprogramming the ECU with Gilomen worked for me and others and you are right for some reason Polaris is not fixing the issue thru their reprogramming.

How often do you change the service light on a Polaris?

Polaris suggests changing the oil every 1,000 miles or 100 hours of driving, whichever comes first. If you are due for an oil change, the service light will come on. After you’ve changed the oil, reset the light to start the next service interval. Turn the key to the “Off” position and remove it from the ignition.

How can I Make my Polaris service light blink?

Select the “Service Interval” choice from the menu on the control panel. Press the “Mode Override” button until you see this option. Press the “Manual Override” button three times. This will cause the light to blink.

How often should I change the oil in my Polaris ATV?

Polaris makes a line of ATVs that, like most vehicles, require regular oil changes. Polaris suggests changing the oil every 1,000 miles or 100 hours of driving, whichever comes first. If you are due for an oil change, the service light will come on. After you’ve changed the oil, reset the light to start the next service interval.

Why is the Check Engine light on on my sportsman 800?

Its a 2007 Sportsman 800 by the way. Any ideas as to why it came on? How can I get it to shut off? Will I hurt anything if I run it with the check engine light on? The quad still runs great even with the light on. Nevermind! I disconnected the battery for about 20 minutes, reconnected everything, fired it up and bye bye check engine icon.

When does the Check Engine light come on?

6+1 is code 61. which is just a factory “end” code. its not a code related to the service engine light. The check engine light comes on just when i turn the key on before cranking it, maybe thats normal, sorry to seem stupid but i just brought it not long ago. once started the lights gone ??

Where is the air sensor on a Polaris ATV?

OK, reading and more reading old posts as well as a couple PMs to members the consensus is the air sensor is the sensor in the duct leading between the air filter and the throttle body. I pulled the sensor, found it a little dirty.

Are there any issues with the Polaris Sportsman 800?

Got about 3000 miles on it. The 500 (wifes) has zero issues with about 2000 miles. Anyone have issues with battery draining. My 2008 . Sportsman 800 battery drains even with positive cables disconnected.

Why is my spark plug not working on my Polaris?

As you get to higher RPM’s, the problem gets worse as the arcing is causing the spark plug to not fire consistently or enough. It can load up the plug and foul it.

What does service wrench icon on Polaris speedometer mean?

by Chris Gilliland. The flashing service wrench icon on a Polaris Sportsman’s speedometer can lead many riders to panic. In most cases, this icon is triggered by the engine’s hours of operation reaching a programmed interval, and it acts as a friendly reminder that your ATV is ready for a routine servicing.

How to reset the service wrench on a Polaris Sportsman?

Select the service interval function by holding the “Mode/Reverse Override” button for three seconds until the service wrench icon begins to flash. Set the next service interval by holding the “Mode/Reverse Override” button to advance the next service interval in one-hour increments.

Why is the engine light on my Polaris Ranger not working?

Took battery out of motorcycle didn’t fit properly so just to see if it would start hooked it up anyway due to bad light and bad eyes hooked it up backwards ( real dumb ass move ) turned on IGN switch fan cam on running backwards I would guess shut it off when I noticed my blunder. Hooked it up right now turns over no start.

What’s the Check Engine light on a Polaris Ranger?

So….I’m riding my 2013 800 this evening and the checkengine light flashed a couple times. By the time I got home…the light was pretty much constantly on and the Ranger seemed to be ‘bogged’ down and didn’t want to run. Had a ‘jumpy’ feeling a couple times.

What’s the engine warning light on a Polaris 800?

Hello, I was reading your posts and thought I’d ask a question about the engine warning light. I am new to UTVs, just bought my first a used 2012 Polaris 800 XP. The engine light came on after driving it about 20 min. There doesn’t seem to be any performance issues. I followed the advise (above) and my code is 0 51 and the fault code is 3.

Why is my engine light on on my Polaris ATV?

This can be caused by holes in the tubing from the air box to the throttle body. Have you run your vent lines into the pod?

How much does it cost to fix a Polaris check engine light?

If wires are good then they are likely coming loose within the actual connector to the T-bap connector. It used to take an entire wiring harness replacement to fix this although some had some home brewed solutions. Polaris now has a repair kit that costs right around $40.00.

Why is the Check Engine light on on my sportsman?

Check Engine light on…need help! Just noticed the check engine light on my quad is on. Its a 2007 Sportsman 800 by the way. Any ideas as to why it came on?

Why does the engine hot light keep flashing?

I HAVE A 2004 SPORTSMAN 400 4X4. AS SOON AS WE TURN IT ON WITHIN 15 SECONDS OR SO THE “ENGINE HOT” LIGHT STARTS FLASHING ON THE SCREEN. WE HAVE CHANGED THE THERMO SENSOR THINKING MAYBE THAT WAS BAD BUT ITS NOT. IT IS STILL FLASHING THAT WARNING SIGN WIHIN A FEW SECONDS OF STARTING IT UP.

Check Engine light on…need help! Just noticed the check engine light on my quad is on. Its a 2007 Sportsman 800 by the way. Any ideas as to why it came on?

Why does my Polaris ATV keep flashing Hot?

So far, I replaced the all the gaskets in the top end of engine, the thermostat is removed, Brand New ECM, and tested the temp sensor (seems to be fine but don’t know what proper reading should be). The Rad is full of new fluid and burped. The rad is free of mud and debris ( and power tested it with leads from battery and works).

Where does the temp sensor go on a Polaris ATV?

The schematic also shows that the temp sensor goes to a box identified as voltage regulator fan hot lamp control and circuit breakers. Then there is a wire that goes from this box to your speedometer to control the hot light. I not sure what is in this box and Its getting late and I don’t have time to read it all tonight.

Navigation