How to change the wiring on a Toyota Celica?

SIZED FOR PRINT REMOVE REAR END COVER a. b. ZOOM 2. Remove the nut and terminal insulator. Remove the bolt, 3 nuts, plate terminal and end cover. SIZED FOR PRINT REMOVE BRUSH HOLDER AND VOLTAGE REGULATOR a. b. c. Remove the brush holder cover from the brush holder. Remove the 5 screws, brush holder and voltage regulator.

How much torque does a Toyota Celica have?

SIZED FOR PRINT REMOVE PULLEY a. b. ZOOM Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque. SST 09820-63010 Torque: 39 Nm (400 kg.cm, 29 ft.lb) Check that SST (A) is secured to the rotor shaft. SIZED FOR PRINT fPage 3 of 9 c. d. ZOOM Mount SST (C) in a vise.

How to install generator washer on Toyota Celica?

SST O9286-46011 Remove the generator washer from the rotor REMOVE ROTOR FROM DRIVE END FRAME REASSEMBLY ZOOM 1. SIZED FOR PRINT INSTALL ROTOR TO DRIVE END FRAME a. b. Place the drive end frame on the pulley. Install the rotor to the drive end frame. fPage 5 of 9 ZOOM 2. SIZED FOR PRINT INSTALL RECTIFIER END FRAME a.

What happens when the IAT sensor goes bad on a Toyota?

When the intake air temperature (IAT) sensor on your Toyota goes bad, the check engine light (CEL) will immediately illuminate to let you know that there’s a problem and that a diagnostic trouble code has set to indicate a problem. Here are some of the specific symptoms you’ll see/have:

How to test the IAT sesnor Toyota Corolla?

Intake Air Temp (IAT) Temperature/Resistance Chart. You can find this tutorial in Spanish here: Cómo Probar El Sensor IAT (1.8L Toyota Corolla) (at: autotecnico-online.com ).