How to adjust tilt lock force on TRW Steering columns?
1. Remove the shrouds from the steering column by removing four T30 Torx screws on the upper driver side and two T30 Torx screws on the upper dash side. 2. Remove the turn signal wiring harness bracket by removing the T30 Torx screw that holds it to the alumi- num column housing. 3.
Why is my tilt lock column not working?
TRW tilt/telescope steering columns in Columbia, Coronado, and Century Class Conventional vehicles may not have the correct tilt lock force if the column does not hold firmly in place after a tilt adjustment. The castle nut can be tightened to provide the correct force.
How do you remove steering column shrouds?
Remove the shrouds from the steering column by removing four T30 Torx screws on the upper driver side and two T30 Torx screws on the upper dash side. 2. Remove the turn signal wiring harness bracket by removing the T30 Torx screw that holds it to the alumi- num column housing. 3.
How to fix GM 3rd gen tilt steering column?
Fixing GM 3rd Gen tilt steering column My steering column can move up and down a bit and now it its so loose the key doesnt want to come out and when i make turns the horn is beeping by itself. The bolts under the dash are tight, it looks like the play is coming from where the steering column tilts.
How do you fix a tilt steering wheel?
Remove the safety clip from the steering shaft, then remove the nut. You might have to have an assistant help hold the wheel while you turn the nut loose. Install the bolts from your steering wheel puller into the tapped holes in the wheel, and turn the puller screw to release the wheel from the steering shaft.
What to do if your steering column comes loose?
The 4 inverted torx bolts have came loose. its a pretty big job if you have never been in a column before. if you fix it yourself, remember to use locktight on the 4 bolts shown below. Your car will be a little easier if there is no VATS wiring and SIR coil/wiring/gas bag.
How do you remove a steering wheel nut?
You might have to have an assistant help hold the wheel while you turn the nut loose. Install the bolts from your steering wheel puller into the tapped holes in the wheel, and turn the puller screw to release the wheel from the steering shaft. Depress the notched wheel locking plate and remove the locking ring located at the center of the plate.