How much is a Mercedes tail light?
Prices of Mercedes-Benz tail light replacements vary depending on which model year a part fits on. Usually they cost around $50 to $590 regardless of product fitting and the quantity being sold. Mercedes-Benz replacement tail lights are sold individually or in sets of two and four.
How to replace taillight bulb on Mercedes Benz E320?
Pull the seal off the lens and place it aside. Remove the three T25 Torx screws for the bulb assembly (red arrows). Remove the bulb assembly (green arrow) from the lens and replace it with a new one. The red arrow points to one faulty bulb, the reason this unit was replaced.
How to replace tail light on Mercedes AMG?
Push against the tail light assembly a little so that you can pull it from the outside. Once you have it removed, pull off the black foam seal on the back and unscrew the three Torx screws to remove the bulb holder. Figure 3. Remove tail light assembly.
Where are the tail lights on a Mercedes Benz W211?
The taillights on Mercedes-Benz W211 sedan models is mounted in the fender. All of the lights (minus the third brake and plate) are mounted in the housing. The taillight lens and bulbs are both serviceable. The bulbs however are only serviced as a complete bulb holder.
Why did my Mercedes Benz taillight bulb burn out?
The red arrow points to one faulty bulb, the reason this unit was replaced. Note the burned plastic (yellow arrow), visible from the trunk on the rear side of the bulb assembly. When installing new taillight lens, check that the taillight seal is in good condition.
When did the Mercedes E Class tail light go out?
This article applies to the Mercedes-Benz E-Class and E-Class AMG (2002-2009). Chances are you’re not even going to notice a burned out tail light until your car gives you an error code.
Can a Mercedes Benz dealer fix a broken tail light?
Mercedes-Benz recommends having your certified dealership fix your broken tail lights, but it turns out that replacing the tail light yourself is actually much less expensive. Read below to learn more.
How do you replace the tail on a Mercedes Benz?
Gently pull them outward then detach the cables inside. Figure 1. Pry off the trunk cover tabs. Remove the two cargo tie hooks by removing the Torx screws in each. Pry out the two fasteners at the top of the lining. Look for a cut in the lining around the trunk lid arms.
Do you have to replace tail light holder?
This is because all the tail light bulbs are soldered onto a circuit board. So when you have to replace a bulb, you’re required to replace the entire bulb holder. You can find these bulb holders online for a little less than what a dealership would charge. Keep reading to learn how to install the tail light (s) in your Mercedes-Benz E-Class.