How much is a head gasket for a Honda Accord?
The average cost for a Honda Accord head gasket replacement is between $1,073 and $1,268. Labor costs are estimated between $747 and $943 while parts are priced at $325.
What should I do before replacing the head gasket on a Honda Accord?
Thoroughly clean the head bolts and stud threads that secure the cylinder head and lightly lubricate with engine oil prior to re-installation. This will reduce strain on the cylinder head and engine block. It will also make it easier to tighten them to the proper torque during reassembly.
How do you replace a blown gasket on a Honda Civic?
Figure 2. Clean the deck of the engine block. After cleaning, it’s recommended to use a level ruler to check if the surfaces of the engine block and the cylinder head are even. If the head is warped in any way, it may need to be machined or even replaced. The new gasket won’t mean much if the head is warped.
What should I remove to install a head gasket?
Remove the parts that are connected to the cylinder head. Refer to your car’s service manual for specifics, but in most cases this involves removing the exhaust manifold, the intake manifold, valve cover and drive belts. On many engines, you will need to remove the timing belt or timing chain.
How do you replace a Honda I4 head gasket?
Loosen the belt tension on both the power steering pump and alternator, then remove the belts. On the power steering pump, there are two bolts—one on the top right and the other on the bottom left. After loosening them, push down on the pump to relieve the tension.
How much does it cost to replace head gasket on Honda Accord?
The average cost for a Honda Accord head gasket replacement is between $1,073 and $1,268. Labor costs are estimated between $747 and $943 while parts are priced at $325. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
Can you replace the cylinder head on a Honda Accord?
That includes time spent working on the car as well as time spent cleaning your parts, obtaining special tools and replacement parts, and dropping off and picking up the cylinder head from the machine shop. But keep in mind that doing it yourself instead of bringing the entire job to a repair shop may yield better quality results.
Loosen the belt tension on both the power steering pump and alternator, then remove the belts. On the power steering pump, there are two bolts—one on the top right and the other on the bottom left. After loosening them, push down on the pump to relieve the tension.
Do you need to replace the head gasket?
Replacing a head gasket is time-consuming. So after you remove the cylinder head, you should determine whether the engine block mating surface is warped by more than .002 of an inch. If it is, a new gasket installation may not fix the problem.