How much does it cost to replace rear wheel sensor?
The average cost for wheel speed sensor replacement is between $209 and $254. Labor costs are estimated between $62 and $78 while parts are priced between $147 and $176. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
Can you repair a broken ABS sensor wire?
However, if you decide to repair the broken wire, you MUST solder it. The electrical signals running through the ABS wiring harness is low voltage and ANY signal loss or voltage drop induced by a crimp connector is enough to create a complete signal loss. You can splice and extend them.
Can you replace wheel sensors?
Replacing a wheel speed sensor is a very straightforward job with the right tools and knowledge. But if it’s something you don’t want to tackle on your own, the professional mechanics at YourMechanic can complete the wheel speed sensor replacement for you.
Can you fix a ABS sensor?
This sort of sensor is used for many different systems on a modern car. Anything that rotates can have a sensor of this type mounted to it so that the powertrain control module (PCM) can monitor its rotation. If the ABS speed sensor fails or does not work properly, you can replace it on your own.
How to replace the rear wheel speed sensor?
Rear sensor: Working at the fuel pump access panel, remove the five 10mm fasteners (red arrows). Then remove the access panel from the vehicle (inset). Rear sensor: Unplug the wheel speed sensor connector (red arrow) by opening the clips (green arrows) and pulling it apart. Then remove the wiring harness from the insulation (green arrow).
How do you change the front ABS sensor?
Front sensor: Using a flathead screwdriver (red arrow), lever the sensor flange (green arrow) side to side to free the sensor from the wheel bearing carrier. Front sensor: Pull the ABS sensor out of the steering knuckle.
Can a wrong sensor be replaced on a car?
It is very common to accidentally replace the wrong sensor, especially when you are working on a car with sensors on every wheel. To ensure that you replace the right sensor, use the multimeter to test the sensor that you suspect is faulty, before you remove it.
What happens when an ABS wheel speed sensor fails?
When an ABS wheel speed sensor fails, the ABS/DSC module loses road wheel speed for the corresponding wheel and sets a fault code for the ABS wheel speed signal. When a fault code is set, the ABS/DSC warning light will illuminate.