How much does it cost to replace a serpentine belt on a Toyota Tacoma?
The Best in Auto Repair The average cost for a Toyota Tacoma serpentine belt replacement is between $93 and $119. Labor costs are estimated between $51 and $65 while parts are priced between $42 and $54. This range is based on the number and age of Toyota Tacoma’s on the road.
How do you loosen the belt on a Toyota Tacoma?
The belt is held in place by the use of a special component called the tensioner. This pulley is mounted on a swivel that can be loosened by rotating it clockwise with a ratchet. When the tensioner is loosened, the belt gets enough slack to give your hands space to remove it.
How many belts does a 2004 Tacoma have?
3 belts
BANDO Replacement for Toyota Tacoma 1995-2004 V6 3.4L Alternator-Air Conditioner-Power Steering Belt Set(3 belts) BANDO 4PK870 4PK1050 4PK1070.
How to change all of the serpentine belts in Toyota Tacoma?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: KP2XspGLgoHr3gjq)
How to change the belt on a water pump?
Use the 14mm wrench for the locking nut and 14mm socket for the adjusting bolt, loosen them only…do not remove. Remove the belt and maneuver the belt around the fan. Step 6. Water pump/AC belt – same thing, use the 14mm wrench and 14mm socket to loosen the idle pully locking nut and adjusting bolt for the water pump/ac to remove the belt. Step 7.
How to change power steering and alternator belts?
Step 4. There are (4) clips holding the half-moon plastic piece to the fan shroud. Just push the clips out and you should be able to remove it easily to have more space for the belts removal in a bit. Step 5. Start removing the power steering belt first and work your way to the alternator last.
What’s the best way to change your belts?
Reinstall the (4) bolts of the fan shroud to the radiator. Step 13. Reinstall the (2) bolts on top of the fan shroud. Step 14. Reinstall the (4) bolts to the front skid plate. Step 15. Start the truck and see if there’s any irregular noises/squeaks and tighten as necessary.