How much does it cost to fix an impeller?
The impeller should run around $30/40 and take about 25 minutes or so. The hardest thing is getting the speedo tube back in place. Just apply greese on the bolts and impeller shaft and jog the propshaft and it should go smoothly. The last one I had put in my 50 hp Merc 4 stroke was about $125 installed.
How often should you change your impeller?
Most mechanics and manufacturers recommend every 3 years more because you don’t want the bolts on your lower unit to cease up more than the actual wear to the impellor.
How to change the impeller in an Evinrude Motor?
1 Stabilize your boat with wheel chocks if it remains on the trailer. 2 Locate the shifting rod that extends down into the lower case. Remove the small coupler bolt that holds the two shifting rods together and pull the coupler out. 3 Note whether the rubber impeller blades inside the case spin left or right.
What happens when an outboard motor impeller is broken?
The impeller is essentially a small, round disc with spinning blades used to move water through the circuit of the outboard motor. When the impeller is broken, it stops the supply of water to the engine and results in overheating.
What’s the best way to fix an outboard motor?
Unscrew the cover plate of the impeller housing. After loosening the screws, pull the cover plate off. Remove the old impeller. Use a pair of pliers to grip the impeller by the blade and pull it off of its shaft. Clear any debris from the housing. Slide a new impeller onto the shaft and screw the cover plate back into place.
Which is the best forum for Evinrude Outboard problems?
This is the best Evinrude Outboard Forum on the internet, it’s yours! Are you looking for good advice about your Evinrude outboard engine problems and issues.
Where is the impeller on an outboard motor?
It is very simple to replace an impeller. You will need to locate the water pump in order to find the impeller. It is usually at the lower end of the motor near where the propeller is attached. You will need to remove the motor’s protective casing in order to locate the water pump.
Can you change the seals on an Evinrude water pump?
In this video I change the driveshaft seal, shift rod o-rings and water pump impeller on the Evinrude 150. MarineEngine.com proudly sponsors the Dangar Marine YouTube Channel.
How often do you need to replace an impeller on a boat?
Because the impeller is in constant contact with the water you may find that it needs to be replaced often, at least more often than other parts on your boat. Impellers tend to rust or corrode if left unattended and the water supply will be cut off to your engine.
What can I do to fix my outboard motor?
With the majority of outboard motors, there is a water output. This small tube can easily become blocked. When this occurs, the water flow is disrupted, causing trouble to the engine. Take a thin piece of wire and run it through the output. Wiggle it around to dislodge any debris that might be inside.