How much does a Subaru Legacy engine hesitate during acceleration?

received a Engine hesitates during acceleration Inspection. Subaru Legacy Engine hesitates during acceleration Inspection costs $85 on average. It can be frustrating for any driver to expect certain acceleration from their vehicle only to find that the vehicle seems to be hesitant while speeding up.

What to do if your Subaru has hesitation?

Most likely you need to replace the plugs, and/or the ignition wires. I have a 2007 Outback that had the same symptoms. Taking the MAF (Mass Air Flow) Sensor out and spraying some electronic sensor cleaner on it removed the hesitation. There are just two screws that hold it in to the intake, so it is a quick operation.

What causes car engine to hesitate when accelerating?

The exhaust gas recirculation valve, or EGR valve, may be damaged and causing a leak. This is known to cause engine hesitation problems, so it should be addressed. If you are using bad fuel which is has been sitting in your tank for too long or is too low of an octane for your engine, it can cause many different problems.

What does it mean if your Subaru is sputtering?

To a non-mechanic, it feels like the fuel supply is sputtering. We have had it to the mechanic 5 times (3 times to Subaru dealer) and, of course, the problem will not showcase itself during these visits. Only once did the check engine light come on, and that reported a possible problem with the throttle position sensor.

Why does my Subaru Impreza hesitate to accelerate?

Also the engine light was on for about a half a year. The car would first hesitate a lot to accelerate and a couple a day ago did not accelerate up a hill. My local mechanic said it could be two things: the flow meter (sensor next to airfliter) or the throttle sensor. To check the flowmeter it is very easy, just disconect the plug.

How much does a Subaru Forester engine hesitate during acceleration inspection?

Subaru Forester Engine hesitates during acceleration Inspection costs $85 on average. Following is a breakdown of the labor and parts estimates. Fast and easy service at your home or office. Real customer reviews from Subaru owners like you. Offered to arrive earlier, which was great! Very friendly and easy to talk to. Quick, great work!

What does it mean when your car hesitates when accelerating?

Instead of going faster by stepping on the accelerator pedal, the speed will be reduced. The vehicle may even stumble entirely during these seconds. This is what it means when the car engine hesitates.

Is there a hesitation problem in a 1999 Legacy wagon?

1999 legacy wagon 2.5-same exact problem everyone else is having, saw this thread and thought yes! Work in an all make shop and have seen tons of weird problems caused by bad grounds. Gotta start with the basics, which we often forget!

Is there a problem with my Subaru Forester?

Just resolved a similar problem on ’03 Forester 2.0 turbo. Car would not respond for 2 to 3 seconds when the accelerator pedal is pushed. Also, when it finally kicked in it lacked power. I did not take it in until check engine light came on for O2 sensor…p0171…

What was the hesitation problem on my Subaru Outback?

My hesitation was due to my plug wire on #3 breaking apart after the last spark plug change (I pulled on the proper location of the wires to take the wires off). I changed them in the parking lot of the local Subaru dealership (when I was out of town!). Fixed.

Why does my Subaru stall when it warms up?

Check them. Fuel pump could be running great and supplying sufficient fuel a for cold running engine and then as it heats up, with the engine, expansion of the metals in the pump or module reduces the pump output. Check the fuel pressure cold, then after the engine warms up and acts up.

What to do about hesitation in a Subaru Outback?

I have a 2007 Outback that had the same symptoms. Taking the MAF (Mass Air Flow) Sensor out and spraying some electronic sensor cleaner on it removed the hesitation. There are just two screws that hold it in to the intake, so it is a quick operation.

What’s the average price of a Subaru Legacy?

Subaru Legacy Engine hesitates during acceleration Inspection costs $89 on average. It can be frustrating for any driver to expect certain acceleration from their vehicle only to find that the vehicle seems to be hesitant while speeding up.

What kind of car is 1998 Legacy Outback?

Hey everyone! Enter your ride HERE to be a part of this month’s Outback of the Month Challenge! I have a 1998 legacy outback which I bought around 4 months ago.

Is there a problem with my 1999 Subaru Legacy wagon?

I have a 1999 subaru wagon with 246K miles. ***The car has been a dream, and has not had any problems other than a bad oil pump and normal maintenance. ***About 6 months ago the car was experiencing a loss of power and wouldn’t accelerate when I pressed the gas. ***I thought it needed a tune up. ***After replacing spark plugs the problem persisted.

Hey everyone! Enter your ride HERE to be a part of this month’s Outback of the Month Challenge! I have a 1998 legacy outback which I bought around 4 months ago.

How do you change the fuel filter on a legacy?

Lift up the cover either in the trunk or in back if you have a wagon. You will see a domed cover held on by 4 screws. Remove this cover to expose the fuel pump. Undo the electrical connection to the pump and crank the engine. This will relieve the pressure in the fuel line. After you change the filter reconnect the pump and replace cover.

How do you ground a Subaru Legacy International?

Here is a link to someone elses Subaru Legacy International • View topic – Grounding mod question .There are pics further down on the page. It is not quite how I did it but it gives you a pretty good idea. I just went to either side of the intake manifold, and to the two strut towers.

Where are the trouble codes on a Subaru?

There are self-diagnositic connectors on all models, when connected with the key ON (engine off), flash trouble codes on the LED light of the oxygen moniter of the ECU. Images used with permission Copyright © 2001 ALLDATA LLC.

Is there an OBD code for a Subaru imprenza legacy?

95 Imprenza and Legacy models have OBD2 systems and require a scanner,but some basic codes can be retreived using the flashing MIL method. Codes will only clear when the faulty system or circuit has been repaired.

What kind of engine does a Subaru Legacy 3.0 have?

The 3.0 R begins with the same standard equipment as the 2.5i Special Edition and adds a six-cylinder engine, SI-Drive and the Torsen limited-slip differential. The 3.0 R Limited sports the same six-cylinder engine along with the luxury features of the 2.5i Limited.

What are the trim levels of the Subaru Legacy?

The 2009 Subaru Legacy is a four-door midsize sedan with standard AWD. There are seven trim levels: base 2.5i, 2.5i Special Edition, 2.5i Limited, 2.5 GT Limited, 2.5 GT spec.B, 3.0 R and 3.0 R Limited.

How to know if your Subaru Outback Legacy is running?

Go out to the car and turn the key to the ON position as if the car is running. Don’t turn it all the way to the crank position. If you hear the low hum of the fuel pump running for a few seconds as the fuel pressure builds up I’d bet you have a leak that’s bleeding off fuel pressure.

What’s the price of a 2010 Subaru Legacy?

The 2010 Subaru Legacy has a Manufacturer’s Suggested Retail Price (MSRP) starting around $20,500 for the 2.5i, with the Premium model adding about $1,000 to that. The 2.5 Limited starts around $25,500, as does the base 3.6 R, while the GT and 3.6R Limited start around $28,500 and top out around $30,000 fully loaded.

Why does my Subaru stall at low idle?

Anyways, the car no longer stalls, and the rpms don’t sporadically dip when at an idle. The idle itself is a little rough, but i’m sure theres other reasons for that. Just wanted to share my experience since it seems a little more common then I thought.

How often do you change the idle on a Subaru?

Wait 10-15 seconds so the electronic throttle body or IACV has time to go to the factory programmed home position. 6) Every 20 seconds or so the idle will be adjusted up and down as the ECU tries to adjust it towards a stoichiometric fuel / air mix.

What causes a Subaru Impreza GC8 to stall?

All the sensors were appearing fine, we pulled out the throttle body and it was pretty gunked up. We cleaned that and the air box out and everything is running much more smoothly now, a steady idle at 750 RPM’s. Thanks again for your response, shaz. Not a problem, cleaning anything completely spaced my mind. Glad you figured it out though.

What kind of suspension does a Subaru Legacy have?

The TS type R, was a 2.0L naturally aspirated DOHC version of the Subaru flat-four, and had comparable trim to the GT’s. B spec TS type R’s were also available, with the same body kit, interior, wheels, and Bilstein suspension. The 250T was a 2.5L naturally aspirated DOHC version of the Subaru flat-four, available in full GT trim.

When did the Subaru Legacy GT / B come out?

The GT/B variation was introduced was a wagon-only model in October 1993 as a more sporting version of the Touring Wagon GT (BG5A), and fitted as standard with ABS brakes, Subaru Sports Suspension, and 16″ BBS cross-spoke alloy wheels.

What does the B stand for on a Subaru Legacy?

The “B” designation stood for Bilstein. The Legacy GT was available for sale around the same time as the Nissan Avenir Salut turbocharged 2.0 L with AWD. The GT-B also offered larger brakes, sway bars, wheels, and some different interior options.

Why does my Subaru have a low power response?

After explaining problem to mech he said it was either the fuel pressure regulator or the fuel filter, I took the opportunity to replace spark plugs, air filter, oil, oil filter, and a very dirty fuel filter (which I believe was the culprit in my case), and of course a very expensive O2 sensor. Car drives like new again…response is super!

Are there any problems with the Subaru Legacy transmission?

Transmission oil temperature light turning on after extended driving despite a previous trip to Subaru for the same problem in June. Covered under warranty.

What causes hard shifting on a Subaru Outback?

Engine load, vehicle speed, temperature, excellerater pedal response, all of these will effect the transmissions shifting charastics. If you drive gas on, gas off, brake on, brake off…this transmission is not for you.

Why does my Subaru Legacy not start up?

Put car back together and it did not start. Rembered I had not plugged in cam position sensor. Plugged in sensor and car started but was running rough. Let it run for 30 seconds or minute to see if it would start running better and it didnt. Turned car off and it would not start again.

When does a 1996 Subaru Outback clear readiness?

1996 Subaru vehicles – Vehicles will clear readiness at key-off. There is no reprogramming available for this line of vehicles. These vehicles should be scanned for MIL illumination without regard to readiness status

How to check OBD on a Subaru Outback?

Search Subaru emissions drive cycle and you get some hits. Here’s one . 1. Make sure the fuel tank is between one-quarter and three-quarters full; half a tank is ideal. 2. Start the engine and immediately drive the vehicle for at least 15 minutes at a speed greater than 50 mph.

Navigation