How much does a Jeep Cherokee 249 transfer case weigh?
Be sure you have a jack under the transfer case, as a 249 transfer case weight almost 100#. Have a drip pan ready. As you remove the transfer case, you may leak a little transmission fluid out. Become a Patron of the JeepSolid garage!! Behind the scenes look at what goes on and a more personal interaction and discussion.
How to remove transfer case from Jeep Cherokee?
Once everything is disconnected from the 249 transfer case, you can start removing the 249 transfer case mounting bolts. These are the bolts that mount the 249 transfer case to the transmission. Be sure you have a jack under the transfer case, as a 249 transfer case weight almost 100#. Have a drip pan ready.
What was the first Jeep transfer case to use?
The Quadra-Trac used a passenger side front and rear output. The Quadra-Trac transfer case was the first Jeep transfer case to use an aluminum case and chain drive. It was also the first Jeep transfer case to use a vacuum selector switch instead of a direct linkage lever.
When did Jeep start using the Quadra Trac Transmission?
Jeep used the Quadra-Trac in lieu of the Dana 20 transfer case behind Jeeps that used the TH 400 automatic transmission from 1973 to 1979 in CJ’s, Jeep Trucks and Cherokees. The Quadra-Trac used a passenger side front and rear output.
When was the Jeep Grand Cherokee transfer case made?
Transfer Cases are tested before leaving the factory. This transfer case was manufactured by New Process. This model is a chain driven, The output is on the driver-side with center rear output. The NP249 was used in Jeeps. This unit has been utilized in Grand Cherokee and Grand Wagoneer from 1993 to 1998.
When did the NP249 transfer case come out?
This transfer case was manufactured by New Process. This model is a chain driven, The output is on the driver-side with center rear output. The NP249 was used in Jeeps. This unit has been utilized in Grand Cherokee and Grand Wagoneer from 1993 to 1998.
What kind of transmission does a Jeep Grand Cherokee use?
The NP249 was used in Jeeps. This unit has been utilized in Grand Cherokee and Grand Wagoneer from 1993 to 1998. The NP249 was manufactured with manual shift, it is a full-time, 2.72:1 ratio, and has a magnesium case has either 4WD full-time, neutral and low 4WD. These units have 23 spline inputs and 27 spline slip rear outputs.
Can a transfer case be built by New Process Gear?
Any transfer case that was built by New Process Gear will be included in the New Venture transfer case line for pur- poses of this article. One of the greatest problems fac- ing the transmission rebuilder and parts suppliers in the last decade or so is the tremendous proliferation of new units.