How many spark plugs does a 2008 Mazda 3 have?
Install each of the 4 spark plugs.
How long does it take to change spark plugs Mazda 3?
Changing spark plugs takes about an hour (for a four-cylinder engine) and will save you at least a hundred bucks in labor if you do it yourself. In most cases it’s a simple job that will help to maintain peak performance and the highest possible gas mileage.
How do you change the spark plug on a Mazda 3?
It is very simple. 5) Pull up on the black coil pack, and the spark plug will be exposed, and allow you to put your spark plug socket into it and twist it out. Tips: Do 1 at a time. Better to leave the spark plug areas covered as long as you can. Easy easy easy, I hope this was helpful.
How to replace the drain plug on a Mazda 3?
Loosen the radiator drain plug completely. 4. Using a flathead screwdriver or equivalent, pry out the radiator drain plug. Do not apply excessive force to the flathead screwdriver or equivalent as doing so can damage the drain bore. Slowly and carefully pry out the radiator drain plug when removing it. 5.
How big is the spark plug on a Mazda Pug?
Tighten the spark plug to: 15 lb. ft. – 14mm spark plugs. 20 lb. ft. – 18mm spark plugs.
When to remove coolant cap on Mazda 3?
Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Turn off the engine and wait until it is cool.
How do you replace a spark plug on a Mazda 3?
With your 8mm wrench or deep socket, remove the first coil pack bolt: 4. With the bolt removed, the coil pack just pulls up from the spark plug. You shouldn’t need to disconnect any cables, just swivel the coil pack out of the way.
Loosen the radiator drain plug completely. 4. Using a flathead screwdriver or equivalent, pry out the radiator drain plug. Do not apply excessive force to the flathead screwdriver or equivalent as doing so can damage the drain bore. Slowly and carefully pry out the radiator drain plug when removing it. 5.
How do you change spark Pugs on a Mazda 3?
This is one of the most common Mazda engines found on Mazda 3, Mazda 5, Mazda 6, CX-5, CX-7. Park vehicle. Park your Mazda on level ground. Allow the engine to cool down. Pull the hood release and open the hood. Disconnect the negative battery terminal.
What are torque specs for Mazda 3 spark plugs?
When you feel some resistance, attach the ratchet and snug the spark plug down. Don’t over-tighten it, since our engines are aluminum and you don’t want to strip the threads. According to the shop manual, the torque specs for the plugs are 10-14 N·m, or 8-10 lb-ft. (Thanks to XCNuse for this info!)