How many revs should my car do at 70mph?
Generally, the average car stays at about 2500 rpm while doing 70mph.
How far can a Toyota Matrix go on a full tank?
On a full tank of fuel the 2011 Toyota Matrix has a maximum range in the city of between 264 and 343 miles depending on the trim level. On a full tank of fuel the 2011 Toyota Matrix has a maximum range highway driving of between 343 and 422 miles depending on the trim level.
What is a good RPM for highway?
You should be looking for 2200-2400 cruising RPM at around 70-75 MPH, at least a 3:73 gear, but check out the article, Hotrodhill.
How do I lower my rpm on the highway?
if you want to lower your rpms on the hwy then add a tooth to the front or take away from the rear. figure out your indicated speed vs your actual speed (either with gps, a cop friend, or one of those radar trailers). this will be a PERCENTAGE. so the faster you go the more it will be off.
What should your RPMs be at 60 mph?
between 2,000 and 2,100rpm
It does between 2,000 and 2,100rpm at 60 mph.
What’s the best speed for a Toyota drive cycle?
Drive at a steady speed between 40 and 70 MPH for 10 minutes. It’s a good idea to stay in the middle of this range, so 55 MPH is optimal. It may take several attempts and warm up cycles to complete the drive cycle. Loading… Be the first to like this.
What’s the best idle speed for a Toyota OBD?
I usually recommended letting it idle for ten to fifteen minutes after sitting overnight. After warming up the vehicle, drive at a steady speed between 40 & 70 miles per hour. Tip: try to stay around the middle of this range (55MPH). Also, in Southern California, it may only be possible to maintain these speeds early on a weekend morning.
Can a Toyota drive cycle complete the catalyst monitor?
The catalyst monitor on many Toyota vehicles can be difficult to complete. That’s why it’s important to follow the Toyota recommended drive cycle after performing actions that are known to clear your Toyota’s computer memory.
When does the readiness monitor complete on a Toyota Camry?
Although the drive cycle for a 2003 Toyota Camry might be slightly different, it’s worth giving it a try. As long as all the emission systems are working correctly, the readiness monitors should complete without setting a fault code (DTC) by the end of the drive cycle. 2004 Toyota Solara 2.4L 4 cyl engine. Drive Cycle for Evap, Catalyst ?