How many miles can you get out of a 1998 Jeep Cherokee?
Looking at the data above, we can say that a Jeep Grand Cherokee can provide you up to 300,000 miles of use. In fact, there are even those that can reach more than 300K.
What to do if your Jeep Cherokee is not running?
Remove the glove compartment insert, operate the air conditioning and move the knob that controls the position of air and notice which motor is not moving the lever to operate the door and replace the motor. If the line is not cold, hook up the air conditioning gauges.
How does the AC work in a Jeep Cherokee?
It starts at the compressor that compresses the Freon to a temperature warmer than the atmosphere and pushes it through the condenser, which releases the heat to the atmosphere. From the condenser, the Freon moves through the dryer which contains a desiccant that removes any moisture in the system.
Where is the high side line on a Jeep Cherokee?
Hook up the red (high side) line to the valve on the small line and the blue or low side to the big line. Make sure that the knobs on the gauges are in the off position. The small line from the compressor that goes to the condenser and then to the firewall is the high side hose. This line contains from 200 to 350 lbs. of pressure.
Where does the Freon go in a Jeep Cherokee?
From the dryer the Freon flows through an H-block, which is similar to an orifice tube in function, where it turns the liquid Freon into a fine spray or vapor. This vapor or spray moves through the evaporator and absorbs the heat within the cabin and returns to the compressor.
How does the idle work on a 1998 Jeep Cherokee?
The idle on the 1998 Jeep Cherokee is controlled by an idle air control valve. This part works with the vehicle’s main internal computer to regulate the air and idle speed of the engine.
Where is the throttle body on a 1998 Jeep Cherokee?
If that doesn’t work, you can replace the part to regulate the idle speed once again. Open the hood of your 1998 Jeep Cherokee. Find the throttle body straight back from the A/C compressor, to the left of the fuel injector and to the immediate right of the air intake temperature sensor on the engine block.
How to replace ignition distributor in Jeep Grand Cherokee?
In Grand Cherokee (ZJ) you have access to this bolt from underneath. Now disconnect the battery negative cable, then disconnect the radiator fan electric connector: Then unscrew (using 8mm socket) two bolts which are also mounting points for coolant reservoir pipe: And remove it simply pulling it up.
What can I use to clean the idle valve on my Jeep Cherokee?
Use only aerosol carburetor cleaner on the valve parts — not on the sensors or anything else around the engine area. Put the idle valve back in place, start the Cherokee and see if this has rectified the problem. If not, take the valve off again and proceed to the next step.