How many horsepower does a Briggs and Stratton 5 hp engine have?
All three of these measurements, plus the number of revolutions per minute, are required to calculate the exact horsepower. The manufacturer rates this engine at 5 hp. As with all internal combustion gasoline engines, the actual horsepower produced will decrease with increases in altitude and temperature.
How much oil does a Briggs and Stratton 135202 take?
The model 135202 engine holds 2/3 quarts, 21 ounces, or 0.6 liters of oil. The manufacturer recommends the use of 30-weight detergent oil. Do not use special additives, as air-cooled engines run hotter than car engines. Keep the oil level at “FULL” and check it every eight hours of engine operation.
How often should you check the oil level in a Briggs and Stratton?
Do not use special additives, as air-cooled engines run hotter than car engines. Keep the oil level at “FULL” and check it every eight hours of engine operation. This engine uses regular unleaded gasoline with a minimum of 77 octane. This is a four-stroke engine, and you do not mix oil with the gasoline.
What should the air gap be on a Briggs and Stratton?
Briggs & Stratton recommends that the air gap setting for the armature be set at 0.010-0.014 inches, or 0.25-0.36 mm; the spark plug gap should be set at 0.030 inches, or 0.76 mm.
When do you set the timing on a Briggs and Stratton engine?
Setting the engine timing on all Briggs and Stratton engines occurs after the rebuilding process. Locate and identify the timing mark on the crankshaft counter weight or the camshaft gear.
What to do with a 15 horsepower Briggs and Stratton?
Drain any excess fuel from the engine fuel tank to prevent fuel spillage. Unscrew the engine cover shroud retaining screws, if equipped, from the engine assembly with a screwdriver to access the engine blower housing. Some 15 horsepower Briggs & Stratton engines require the fuel tank to be removed before removing the engine blower housing.
How do you change the breaker point on a Briggs and Stratton?
Unscrew the engine blower housing retaining bolts from the engine assembly with a socket wrench. Lift the engine blower housing from the engine assembly. Some 15 horsepower Briggs & Stratton engines are equipped with external breaker points that must be checked and adjusted periodically.
How do you remove a Briggs and Stratton engine?
Drain the fuel and oil from your engine. Remove the blower housing. There are two bolts attaching the housing to the engine. One is near the cylinder head, the other at the base of the engine. Use a socket wrench to remove the bolts and lift the housing from the engine. Remove the cylinder shroud and slide shroud.