How long does it take to replace the hood release cable?
In order to replace the this important cable, you will need to remove the hood latch and uninstall several bolts. Although it may seem complicated, replacing the hood release cable on your Ford is a relatively simple process that should only take about one hour.
Where is the hood release cable on a Ford?
The hood release cable on your Ford vehicle is the wire connector that allows you to open the hood when you pull on the hood release lever. In order to replace the this important cable, you will need to remove the hood latch and uninstall several bolts.
How do you install a new engine cable?
Install the new cable by running it through the fuse panel access hole that leads into the engine compartment. Reattach the bolts in the fuse panel and the clips along the firewall. Reattach the hood latch and attach the cable to the latch. Daniel Valladares began his career as a medical writer in 2008.
How do you replace a hood release cable?
Here’s how to replace a locking hood release cable at home. If the hood is closed, open it by inserting a screwdriver to move the latch’s tongue to the side. When you move it, pull the hood open with the other hand, secure the hood, then remove the hood latch mechanism (2 8mm bolts). Figure 1.
How do you replace the hood release on a Ford F-150?
Hood release cable route. Remove the two bolts holding the hood release handle from the bottom of the dash. Once the handle is free, unscrew the cable off of it, and feed the cable through the firewall and into the truck’s cabin. Figure 4. Remove the hood release handle with a wrench or a power drill with a socket end.
What is the wire on the hood of a Ford?
by Daniel Valladares. The hood release cable on your Ford vehicle is the wire connector that allows you to open the hood when you pull on the hood release lever.
Install the new cable by running it through the fuse panel access hole that leads into the engine compartment. Reattach the bolts in the fuse panel and the clips along the firewall. Reattach the hood latch and attach the cable to the latch. Daniel Valladares began his career as a medical writer in 2008.