How long does it take to replace spark plug wire on Ford Ranger?
Please try again later. Spark Plug Wire Replacement on a Ford Ranger. This video shows how to replace the spark plug wires on a V6 Mazda B3000 (Ford Ranger). It is a straight forward process and will take about 2 hours if you take your time.
How do you change the spark plug wire in a car?
It really does not matter where you start, but do not take off more than one wire at a time. If you mix up the location of the wires, the engine will not run right, if at all. Grasp the spark plug wire at the boot on the distributor or coil pack. Twist it slightly as you pull straight off the terminal.
How long does it take to replace spark plug wire in Mazda B3000?
This video shows how to replace the spark plug wires on a V6 Mazda B3000 (Ford Ranger). It is a straight forward process and will take about 2 hours if you take your time. These new wires increased my fuel economy from 16mpg to 17.5mpg and the idle is a lot smoother now.
Do you need an ohmmeter for spark plugs?
You’ll need an ohmmeter for this, and you’ll need to know what the wires’ original resistance was. Test each wire and look for resistance levels higher than when originally installed, as well as higher resistance in individual wires (which indicates a failed wire).
Do you remove spark plug from ignition coil?
Do not remove the spark plug wire from the spark plug or the ignition coil while the engine is cranking to test for spark. Start your Diagnostic from TEST 1, do not skip around from test to test unless instructed to do so by the TEST you are currently on.
How do you replace a spark plug wire?
Spark plug wire replacement tip: To remove spark plug wires from the plug without damaging the boot or wire, use a spark plug boot puller tool instead of a pliers. Click here to see the tool I recommend Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period.
How big of a spark plug wire do I Need?
To test them you’ll need an ohmeter. The actual value you get from testing each wire isn’t as important as the consistency between the wires. So if you test a 3-ft spark plug wire and get a reading of 10,000 ohms, all other 3-ft. wires should test the same.
How many wires are in a Ford coil pack?
The Ford coil pack connector has three wires coming out of it. No matter what the style of coil pack or the style of connector that connects to it, the circuit descriptions are the same. Switching Signal Circuit for spark plugs 1 and 4. Switching Signal Circuit for spark plugs 2 and 3.