How is the rear axle connected to the differential?
The inner end of the each half shaft connected to the sun gear of the differential and the outer end to the wheel. The rear axle and differential gear are completely encloses in a housing which protecting them from water, dust and injury.
How is the rear axle of a car classified?
Rear axle classified by two methods. 1. According to the design of axle: This type of axle is a single shaft and final drive assembly is carried in a separate casing which is bolted to the axle housing. The banjo construction is often used for smaller and lighter vehicle.
How are the wheels fitted at the end of the axle?
The wheels are fitted at the end of the axle by means of a key, bolt or nut. The weight of the vehicle is supported partly by the axle casing and partly by the axle. The main advantage of this type of axle over the half floating axle is that the major part of the load is taken by the axle casing and not by axle.
Where do I find my rear end gear ratio?
You can typically find your RPO code on driver side door panel or glove box. General Motors rear end differentials are referred to by the diameter of the ring gear, i.e. 7.5 inch, 8.5 inch, 10.5 inch. Our experts will help you find the correct ring and pinion set for your particular application. Give us a call at 800-216-1632 to get started.
What do you need to know about rear axle assembly?
When it comes to shopping for an axle assembly you will find people will also refer to them as a rear end assembly or a rear differential. All of these terms are used by people to describe what part they are looking for when shopping online. A rear axle assembly will include an axle housing, axle shafts, ring and pinion, gears and seals.
Where does the differential gear box come from?
The differential is made up of a system of gears that connect the propeller shaft and rear axles. It is a part of inner axle housing assembly.
What to do with a broken rear axle?
Once that is done, we usually tear it down to a bare housing, repair what is broken, inspect the rest of the axle assembly then replace the seals and reassemble the axle assembly. Some dual-wheel rear axle assemblies suffer spindle failure, we are able to replace the spindle, hub, rotor bearings and axle shaft.
Can a hub be replaced on a rear axle?
Some dual-wheel rear axle assemblies suffer spindle failure, we are able to replace the spindle, hub, rotor bearings and axle shaft. This can save you a lot of money instead of buying a rebuilt axle assembly.