How is the governor connected to the throttle?
One end of the governor arm connects to the throttle linkage, and the other end is connected to a governor spring. Governor Spring – The governor spring is attached from one end of the governor arm and to the throttle control of the machine.
How is the governor attached to the cross shaft?
Governor Arm – The governor arm is attached directly to the governor cross shaft. One end of the governor arm connects to the throttle linkage, and the other end is connected to a governor spring. Governor Spring – The governor spring is attached from one end of the governor arm and to the throttle control of the machine.
How do you adjust the governor on a LEV engine?
For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle. To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open.
How does the Governor work in an engine?
As the throttle closes, the RPMs slow. The governor spring, on the other hand, is always applying tension to the other end of the governor arm which is pulling the throttle open. As the throttle opens, your RPMs speed up. When the two opposing forces—centrifugal force and spring tension—are equal to each other a constant RPM is achieved.
For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle. To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open.
What causes the governor to move the solid link?
Changes in engine R.P.M. cause the governor lever to move the solid link that is connected from the governor lever to the throttle in the carburetor. The throttle is opened when the engine R.P.M. drops and is closed as an engine load is removed.
How can I change the sensitivity of my Governor arm?
Many governor arms have several holes in the arm to change sensitivity. By moving the governor spring to a hole further away from the governor shaft you will make it less sensitive. Before playing with this, check the repair manual for the engine you have and see if it has a way of adjusting sensitivity.
Which is the correct direction to turn the Governor shaft?
First The governor shaft should always be turned in the same direction the governor arm turns to open the throttle wide open. For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle.