How is rain getting in my trunk?
The lid of your trunk has a large rubber seal all the way around it. If that seal becomes cracked, worn, or damaged in some way then there is a chance that when it starts raining or you go into the car wash water will flow into the trunk as a result.
How do you change the head gasket on a Honda Civic?
Unplug all wires and hoses connected to the cylinder head and remove the head cover. You may need to remove the A/C fan to be able to clear it of the studs on the engine block. Set the motor to “top dead center,” or TDC. Remove the #1 cylinder’s spark plug as well as the valve cover so you can observe the springs.
How do you replace the exhaust pipe on a Honda Civic?
Before you install the new exhaust, attach the gaskets to both ends of the middle exhaust pipe, and then slide on the rubber hangers. Connect the middle exhaust pipe to the catalytic converter. Then tighten the bolts until the gasket is sealed. You will need to do the same for the muffler.
What should I do if my Honda Civic trunk is leaking?
There are guide holes to help you install the gasket properly. Use a small drop of silicone or other type of adhesive to attach the gasket in place. Reassemble in reverse. Reconnect wiring beneath gasket, replace bulbs, re-install six nuts holding panel in place, and re-install round clips.
How do you jack up a Honda Civic?
Set your car on jack stands. (Related Article: How to Jack Up Your Civic – Honda-Tech.com) Remove the two bolts attaching the muffler to the exhaust. As you loosen the nut with a socket wrench, you will need to hold the bolt still with an open ended wrench. After removing both bolts, slide the rubber exhaust hangers off the metal hooks.
How do you replace a blown gasket on a Honda Civic?
Figure 2. Clean the deck of the engine block. After cleaning, it’s recommended to use a level ruler to check if the surfaces of the engine block and the cylinder head are even. If the head is warped in any way, it may need to be machined or even replaced. The new gasket won’t mean much if the head is warped.
How do you replace the head gasket on a Honda Accord?
It’s recommended that you install new bolts and studs when replacing the head gasket. They are inexpensive, and also give your engine added support. Re-install the threads to their respective locations. The threads should be hand-tightened to a snug fit. Use the threads as a guide to fit the new gasket onto the engine block.
How to install most Honda carburetors / gasket sequence?
HOW TO INSTALL MOST HONDA CARBURETORS / GASKET SEQUENCE!! – YouTube If playback doesn’t begin shortly, try restarting your device.
Why does my Honda trunk fill with water?
Going me through the process of elimination I was able to determine why Water was leaking into the trunk. I would have gambled that the gasket seals for the lights were possibly failing. Until now I have never personally come across this cause and type of leak. I hope this proves to be helpful for others. Loading…