How far should the belt move when checking a belt for proper tension?
Checking the belt tension Hold the belt between finger and thumb at this point and move it from side to side. See how much it deflects at the centre of the run. If it moves more than 1/2 in. (13 mm) it is too slack – any less movement and it is too tight.
Which belt is used to transmit power at high speed?
flat belt
The flat belt is a simple system of power transmission that was well suited for its day. It can deliver high power at high speeds (373 kW at 51 m/s), in cases of wide belts and large pulleys.
What kind of belt tensioner does Spyder use?
The Spyder Extras Billet Aluminum Belt Tensioner drastically reduces belt vibration by applying smooth spring loaded tension to the drive belt. This RT tensioner is 2″ longer than the factory plastic Can-Am idler for superior damping.
How can I reduce the vibration on my can Am Spyder?
Reduce Belt Vibration on your Can-Am Spyder with one of our Belt Stabilizers, Tensioners or Idlers. These products will reduce vibration of the Spyder drive belt by applying smooth spring loaded tension to the belt itself.
Which is better RT belt tensioner or plastic idler?
This Belt tensioner is 2 inches longer than the OEM plastic idler and offers Superior Dampening. The Spyder Extras RT Belt Tension has Maintenance-Free Operation : Oilite Bronze Bushing @ pivot point for smooth & non binding operation, self lubricating as the arm pivots.
How long is the belt on a can Am Spyder?
The Can Am Spyder uses an exceptionally long drive belt, 40″ between the front drive sprocket and rear sprocket. This extreme length may cause the belt to create harmonic resonance and belt vibration.
The Spyder Extras Billet Aluminum Belt Tensioner drastically reduces belt vibration by applying smooth spring loaded tension to the drive belt. This RT tensioner is 2″ longer than the factory plastic Can-Am idler for superior damping.
When does the can Am Spyder RT belt vibration occur?
One of the issues we’ve noticed with the Can-Am Spyder RT is that belt vibration occurs when the Spyder drivetrain is under load. Some examples of when belt vibration may occur are when you’re riding with a passenger, climbing a steep incline or pulling a trailer.
What kind of bearings are in Spyder Ryder?
The mounting bracket is constructed of 3/16″ stainless steel and attaches to the swing arm with a 3/8″ U-bolt, Nordlock anti-vibration washers and grade 8 Nylock nuts. The idler is constructed of fiberglass impregnated nylon and contains a 6203-C4 bearing for sustained high speed use and long life.