How does the TPS work on a Suzuki SV1000?
The TPS senses what revs the engine is running at and then ‘instructs’ the fuel injection and engine management systems to make adjustments (basically to start squirting more or less fuel into the cylinders).
How does the throttle position sensor ( TPS ) and idle air control valve work?
This Video explains how the Throttle Position Sensor also known as TPS and the Idle Air Control Valve ( IAC ) Work. On the previous 2 Videos I explained how the Fuel is delivered to the Fuel Injectors by the Fuel Pump, I also explained the parts involved to make that happen.
What should idle speed be on Suzuki SV1000?
It should be about 1200rpm. 6) If (as above) the idle is too low, locate the idle adjust screw – on the left hand side of the bike in one of the triangular recesses in the chassis and adjust. Turn clockwise to raise the idle speed and anti-clockwise to lower it…
How to set air mixture in Suzuki GSX?
Set your screw at 1 turn out from lean stumble. DO this with each carb. You can’t say each carb needs 3 turns out, etc. Float height varies from carb to carb on the rack so your mixture screw setting will change with each carb. Finally reset your idle speed and you’re done. If you’re at 3 1/2 turns or more, you need the next size idle jet.
Where is the TPS on the throttle body?
Locate the TPS on the throttle body near the air intake hose. Verify that the throttle valve is closed. Unplug the connector from the throttle position sensor. Measure the resistance between the TPS connector terminals “A” and “C” with a multimeter.
How to adjust tension on throttle cables, Suzuki?
I replaced the Yamaha cables with Teleflex Xtreme. Took the boat out for a test run. After launching the boat, I immediately noticed that it required more foward travel on the shifter for motor to engage in gear. The reverse gear appears fine. The control lever shifts smoothly into foward and reverse. WOT speed is still the same.
Where is the air screw on a Suzuki?
The air screw is on the side of the carburetor and meters the amount of air that makes it to the pilot jet nozzle. A fuel screw is located underneath the float bowl and meters the amount of fuel that makes it to the carb’s main body.
How to adjust the TPS on a 1994 Toyota pickup?
How to Adjust the TPS on a 1994 3.0 V6 Toyota Pickup Remove the air cleaner lid and the air duct leading to the throttle body using the Phillips screwdriver. Pull the air duct off the throttle body. Stick the pin in the center wire of the throttle position sensor plug.