How does the Mitsubishi Eclipse Convertible top work?
The Mitsubishi 4th gen Eclipse convertible is a cloth convertible top with a back window bonded to the fabric. The top raises and lowers by way of a hydraulic rotary actuator with 2 hydraulic cylinders for raising and lowering the 5th top bow and 1 hydraulic cylinder for raising and lowering the tonneau cover.
How is the hydraulic system on a Mitsubishi Eclipse?
The hydraulic system is operated by a single pump run by an electric motor, and with valving which is triggered by electronics which receives signals from certain switches I’ll describe later. When the top is closed, it is secured at the 1st top bow to the windshield header by two manually operated mechanical latches.
What to do if your convertible top is not working?
Check for broken wires or in the case of the top up/down switch on the side of the hydraulic motor, maybe the bracket is bent and the switch isn’t contacting properly. You might be able to fix broken wires or bent brackets on your own. Otherwise it might be a bad switch which would require a replacement part.
What are the problems with the Eclipse Spyder roof system?
One very common problem with the 2g Eclipse Spyder roof system, and one that will effect all cars at some point, is the elastic straps connecting the floating rib to the 2nd rib. The elastic gets all stretched out. The elastic straps are connected by plastic clips that snap over the top of the ribs.
How can I Fix my Spyder convertible top?
Mark the webbing in fully up and latched position, retract the roof partway, line up the webbing over the rib, and fire in some staples. Be sure they go in all the way. Roof does will not raise or lower electrically. Before tearing anything apart, verify that the switch is not set to manual.
What causes a bent top on a Spyder?
The improper folding of the roof during retraction causes a couple of other problems. The worst of these is bent links that connect the floating rib to the side frame. You can access these by pealing back the headliner from the front. It’s held by a couple of screws at the corners and a strip of heavy Velcro.
When did they start making convertible top parts?
We have been manufacturing and distributing convertible tops and convertible top parts for the industry since 1975. We manufacture convertible top parts that are included in most replacement convertible tops and SUV soft tops now being used.
What are the accessories for a convertible top?
Convertible Top Accessories. There are important components of a convertible top installation that are not part of the actual convertible top. The important ones are the top hold down cables, the frame bow tacking strips, the convertible top pads (or webbing), the top’s rear well liner and possibly other items.
Is the 2008 Mitsubishi Eclipse Spyder a convertible?
In the realm of four-seat, under-$30,000 convertibles, the 2008 Mitsubishi Eclipse Spyder is one of the sportier entries. Now in its second year since a full redesign, the Spyder carries over mostly unchanged, offering the same radical styling and solid driving experience.
When was the last time I drove a Mitsubishi convertible?
Purchased on 09/19/06 and owned in CA until 05/22/21. Driven an estimated 6,654 miles/year. Last serviced at 97,795 miles in El Cajon, CA on 06/08/21 • Vehic… No accident or damage reported to CARFAX.
Is the Mitsubishi 4×4 convertible in good condition?
Starts and drives without any issues Bulletproof Engine and Gearbox Changes all gears as it should All 4X4 works Bodywork in very good condition for the a