How do you wire a road King handlebar?
The extension wires have a female end. You simply plug the stock wires into the female end of the extension and shrink tube it with the provided shrink tube. Then cover the whole bunch with the larger provided shrink tube. I use a length of wire as a fish tape to pull the wires through.
Where does throttle wire come from on road King?
THe right side is a bit tricky because the throttle by wire comes through the end of the bar and not the access hole. You also must be careful because the throttle wires. Theyare connected with pin connectors at two places within the bar. You don’t want them coming undone.
How to wire handlebars internally on a Harley Davidson?
Fortunately, installing the wires internally is a relatively simple process, which you can do yourself. If you plan to harness yourself. The process is that simple. You will require three items to complete this job: make some initial preparations. wire. You are going to be attaching the other wires to this wire before
Where are the Phillips head screws on a road King?
There is a Phillips head screw at the 6 o’clock position on ring. Remove the 8 screws that hold the headlight in place. Be very careful not to start loosening alignment screw. Remove trim by removing screw found at front of trim. THis will expose 2 Phillips head screws. Remove them.
THe right side is a bit tricky because the throttle by wire comes through the end of the bar and not the access hole. You also must be careful because the throttle wires. Theyare connected with pin connectors at two places within the bar. You don’t want them coming undone.
The extension wires have a female end. You simply plug the stock wires into the female end of the extension and shrink tube it with the provided shrink tube. Then cover the whole bunch with the larger provided shrink tube. I use a length of wire as a fish tape to pull the wires through.
How tall can a bar be on a road King?
Thanks in advance, Mike I don’t wee how you can add a three inch taller bar without having to add at least three inches to your cables and wiring. You’ll have to measure the slack you have in the cables, some have made the change using the stock cables by rerouting them a bit.
Do you need a throttle clamp on a road King?
Started to buy cables and extensions, a buddy says wait and let measure everything once we see their length. Lo and behold there was plenty of slack on cables and only needed one electrical ext fopr throttle. Saved some bucks. Did need a new clamp for aftermarket step down bars.