How do you turn on the laser on a Craftsman miter saw?
Grab the assembly tab and use the tab to slide the assembly forward. Push the guide lever back in its original position to lock the laser guide in place. Plug in the saw. Press the rocker switch on the front of the assembly to turn on the laser.
Where is the lock pin on a Craftsman miter saw?
Lock pins are typically located on the right side of the hinging mechanism, the side opposite the blade. To lock and unlock the pin, the blade must be in the farthest down position. The pin will not unlock, even though the saw is down.
Where is the model number on a craftsman compound miter saw?
Page 33 CRAFTSMAN The model number will be found on a plate attached to the motor housing. Always mention the model number in all correspondence regarding your COMPOUND MITER SAW or when ordering repair parts. PART NUMBER DESCRIPTION 976528-001 Torsion Spring Page 34 CRAFTSMAN COMPOUND MITER SAW – MODEL NUMBER 315.235380 FigureC “13…
How big is a 10 in compound miter saw?
10 in. BLADE A 10 in. saw blade is included with your compound miter saw. It will cut materials up to 3-9/16 in. thick or 5-9/16 wide, depending upon the thickness of the material and the setting at which the cut is being made.
What happens if my compound miter saw fails?
COMPOUND MITER SAW If this I:RNFT$1_IIN Compound Miter Saw fails due to a defect in material or workmanship.within one year from the date of purchase, Sears will repair it, free of charge. WARRANTY SERVICE IS AVAILABLE IN THE UNITED STATES. Page 3 READ INSTRUCTIONS KNOW YOUR POWER TOOL.
What causes overloading on a sliding miter saw?
MOTOR is overloaded – overloading can occur if thickness of insulation between you and tool’s electrical you feed too rapidly or make too many start/stops system. Page 6 RECOMMENDED ACCESSORIES Supplied Not supplied ….