How do you turn on Eitms on a Harley Davidson?
EITMS can be enabled or disabled by the rider by performing the following procedure.
- Turn the ignition switch to the ON position and push the engine OFF/RUN switch on the right handlebar to the RUN position (do not start the motorcycle).
- Push the throttle to rolloff position and hold.
- See Instrument Lamps.
When did my Wife’s Harley start to misfire?
My wife’s 2005 FLHTCUSE2 began to develop problems a few weeks ago. After a short ride, we stopped for her to get gas. On the way home, her Harley started to misfire and run poorly. I lost sight of her so I pulled over. After about 15 mins she showed up and said her bike would not stay running.
Why does my Harley Davidson have a lean Miss?
Since it does not happen during mixture enrichment times (warm up w/ extended injector duration or “choke” times), it almost points to a lean fuel issue or a lean miss. As soon as the warm-up enrichment period ends, the bike experiences the miss.
When does a Harley Davidson engine misfire at low speeds?
However, when cruising along about 25-30 mph (in either 2nd or 3rd gear) it is always misfiring and sputtering pretty bad now (had a little hint originally and definitely getting worse now). After coming to a stop, the idle is a bit rough and sometimes the engine acts like it wants to cut out for a few seconds after which it seems to idle OK.
Is there a way to adjust timing on a twin cam engine?
Hello Cap, there is no way to adjust timing on a Twin Cam engine. Your crank position sensor reads your flywheels and sends that info to your ECM or ICM (carburated). Early T/C’s also used a cam position sensor. – Dennis Related Video: Cam Chain Tensioner Class Have a question you want answered by a Fix My Hog expert? Send us your question here.
When did the twin cam motor come out for Harley Davidson?
1999-2006 Harley Davidson introduced the Twin Cam motor. In order to run the valve train Harley went to a cam chain tensioner set up utilizing a spring loaded shoe putting pressure on the cam chain with push rods. They also used, and I can’ remember the technical name of the chain, an older chain design.
Are there any problems with Harley Davidson cams?
Other’s had problems at unexpected times. Harley will tell you that if you are going to replace the shoes or do the upgrade you might as well do new cams, its no more in labor because the cam chest is already open, just the price of parts and a lifetime of reliability if you go gear drive.
When do Harley Davidson twin cam chain tensioners wear out?
They also used, and I can’ remember the technical name of the chain, an older chain design. Indeed the cam chain shoes would wear out partly because of the shoe and partly because of the chain. Harley recommended getting them checked between 35 and 40K miles. Problem is they could give out ANY time and were not covered under warranty.
My wife’s 2005 FLHTCUSE2 began to develop problems a few weeks ago. After a short ride, we stopped for her to get gas. On the way home, her Harley started to misfire and run poorly. I lost sight of her so I pulled over. After about 15 mins she showed up and said her bike would not stay running.