How do you tell if my Sportster is a 1200?
The way to tell if a stock h-d sportster is an 883cc or a 1200cc is to look at the VIN number. A 1200cc will start with 1HD1 while a 883cc will start with 1HD4. The number in the fourth position of the VIN designates the engine size when it came from the factory.
How many cc’s is a 1200 Sportster?
2020 Harley-Davidson Sportster Iron 1200 Claimed Specifications
| Price | $9,999 |
|---|---|
| Displacement | 1,202cc |
| Bore x Stroke | 88.9 x 96.8mm |
| Horsepower | N/A |
| Torque | 73 lb.-ft. @ 3,500 rpm |
What should the electrical reading be on a Harley Davidson Sportster?
A normal reading is between 140 to 180 amps. A lower reading indicates a low battery charge or a starter with a internal electrical problem. A higher reading indicates a mechanical problem with the engine, starter, or high resistance in the starter to battery wiring/starter ground wire.
How to check ignition resistance on Harley Davidson Sportster?
Set your meter to read ohms and place your red probe on the positive post of the coil. Place the black probe on the negative post. Your reading should be between three and four ohms. Measure the resistance of the secondary winding.
How to check spark plugs on Harley Davidson Sportster?
Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. Refer to the article Fuse Box Information for fuse locations. Crank the engine and watch for spark. If spark is consistently present, the problem most likely lies with the spark plugs and you should continue to Step 2.
How to find a short on a Harley Davidson Sportster?
Another test to locate a short is by using a compass. Run a compass along the affected circuits wiring and watch for fluctuations in the needle. When a fluctuation is noticed, you may have found the shorts location. This works best with larger parasitic draws.
How to check the oil level on a Sportster?
sportster oil level 1 Position motorcycle so that it is leaning on jiffy stand. 2 Remove filler cap. See Removing and Replacing Oil Filler Cap above. Wipe attached dipstick clean. Reinstall oil… 3 Remove oil filler cap again and check oil level on dipstick. More
What should spark plug reading be on Harley Davidson Sportster?
Place your red probe on the positive post of the coil. Place the black probe on the spark plug wire terminal. Your reading should be between 10,000 and 20,000 ohms. Later model Sportsters use a wiring connector instead of individual posts on the coil.
How to test the power of a Harley Davidson Sportster?
To test your module’s power and grounds: Find the wiring diagram for your year’s Sportster in a service manual, or from your local Harley dealership. Locate the power and ground wires. Measure the power wire’s voltage. Set your meter to read DC volts.
Where is the ignition sensor on a Harley Davidson Sportster?
The crankshaft position sensor location. The I.C.M. (ignition control module) was used on Sportsters before the year 2007. After 2007, the module became integrated into the E.C.M. (electronic control module). These modules contain internal circuitry found on most computer motherboards.