How do you start a 2013 Street Glide?
See Starting the Engine for detailed operation procedures.
- See Ignition Switch. Turn ignition switch to IGNITION.
- Put the engine off/run switch in the RUN position and the transmission in neutral. Neutral. (green) indicator lamp should be illuminated.
- Push the START switch to operate starter motor.
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
What’s the voltage on a Harley Davidson Street Glide?
It’s pretty much done this since day one with the OEM manual stating the gauge will read 13v-14.5v when running. Question: is the fluctuation to 13v at freeway speeds the regulator cutting back the voltage with the battery now fully charged at freeway speed/rpm and recharging at the 14.5-14.7 when on streets or…..?
Why does the battery shunt the voltage on Street Glide?
Thanks again for such a great site! Yes, once the battery is fully charged the regulator will shunt the voltage it does this for 2 reasons 1 the battery does not need the voltage 2 by shunting it gets rid of heat to protect itself Blue Wide Glide, Fisherking and zoob2 like this.
What should I do if my Harley Davidson won’t start?
Here’s where to start your search when your bike won’t start and you have no idea why. This article applies to the Harley Davidson Touring models (2009-present). So the weekend has finally arrived. Boots on, gloves, jacket and helmet: check. You even checked your tires: 36 front and 38 rear.
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
What to do when your Harley Davidson won’t start?
Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.
Why is my Harley Davidson Road King not starting?
If you have a Tachometer, disconnect it. A bad tach can interrupt proper coil function. i have problem error code U1301 in Harley Davidson Road King 2009 and test everything not starts . I have a 92 FXRSP, I recently replaced my switches and I had a new battery.
Can you start a Harley Davidson HD without a fob?
Starting your HD without a Fob! Your HD has the ability to be started without a Fob present jus in case the Fob is lost or the battery goes dead! Your Pin# to over-ride the security system is usually loaded up with the last 5 numbers of your Harley’s serial # backwards! (EX: serial # last 5 is 1 2 3 4 5……….it was entered as 5 4 3 2 1).