How do you shift the clutch on a MerCruiser?
Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise. Continue this action until the propeller shaft stops, indicating that the clutch is fully engaged. This action pulls the shift cable inward.
What to do if your transmission is stuck in gear?
If your transmission is stuck in gear and you are far away from home, try this: 1 Pull over and turn the car off. Remove the key. 2 Do not press the gas pedal or any other buttons on the car. 3 Wait 20 seconds. 4 Start the car and drive to see if it is out of limp mode.
How to adjust the shift on the Mercruiser Alpha One?
Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise. Continue this action until the propeller shaft stops, indicating that the clutch is fully engaged.
How do you shift the throttle on a MerCruiser?
Move it by loosening the stud nut with an open-end wrench. Push it into place with your fingers and tighten the nut. Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise.
Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise. Continue this action until the propeller shaft stops, indicating that the clutch is fully engaged. This action pulls the shift cable inward.
Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise. Continue this action until the propeller shaft stops, indicating that the clutch is fully engaged.
If your transmission is stuck in gear and you are far away from home, try this: 1 Pull over and turn the car off. Remove the key. 2 Do not press the gas pedal or any other buttons on the car. 3 Wait 20 seconds. 4 Start the car and drive to see if it is out of limp mode.
Move it by loosening the stud nut with an open-end wrench. Push it into place with your fingers and tighten the nut. Shift the cable into the wide-open throttle position using the controls at the driver’s station while your assistant rotates the propeller counterclockwise.