How do you set the liftgate open height?
“Setting the Liftgate Open Height 1. Open the liftgate. 2. Stop the liftgate movement by pressing the control button on the liftgate when it reaches the desired height. Note: Once the liftgate has stopped moving, you can also manually move it to the desired height.
What does it mean when liftgate does not turn on?
If both switches do not turn the liftgate on, then you probably have a broken wire inside the pump & motor box. f. Motor runs but platform goes down when the up button is pressed. Hoses are reversed where they connect to the power unit box. 3.1) Platform does not lower down a. Motor does not run.
How do you open a back door liftgate?
To open the manual liftgate, press the request switch and pull up on the handle. An automatic back door power liftgate is available as an option. The power liftgate can automatically move from the fully closed position to the fully open position in approximately 5 to 8 seconds.
What to do when liftgate platform goes out of sync?
Power the liftgate platform up to the top before locking the platform. Hold the button at the top for 5-10 seconds to relevel the platform. Sometimes if the platform goes out of sync it may need to be relevelled at the top before it goes into the locks properly. 6.1) Platform leaks down.
Is there a way to reset the power liftgate?
The power liftgate may not operate properly and may need to be reset if any of these conditions occur: To reset the power liftgate: 1. Disconnect the battery for 20 seconds then, reconnect the battery. 2. Manually close and fully latch the liftgate. 3. Power open the liftgate by using the transmitter, or the instrument panel control button.
If both switches do not turn the liftgate on, then you probably have a broken wire inside the pump & motor box. f. Motor runs but platform goes down when the up button is pressed. Hoses are reversed where they connect to the power unit box. 3.1) Platform does not lower down a. Motor does not run.
How do you unlock a power door liftgate?
Unlock the liftgate with the transmitter or power door unlock control. If the intelligent access transmitter is within 3 feet (1 meter) of the liftgate, the liftgate will unlock when you press the liftgate release button. 2. To open the liftgate, press the control button located in the top of the liftgate pull cup handle.
Where is the disable switch on GM power liftgate?
Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack.