How do you reset the tire pressure light on a VW Routan?
Turn the ignition to on and then on the Multi-function Indicator (MFI), go to the SETTINGS menu. Select tire pressure and then store and confirm the current tire pressures. Then drive the vehicle for around 20 minutes over 15 mph.
How do I know my TPMS frequency?
The frequency of the sensor used is determined by the vehicle manufacturer. The two frequencies are not interchangeable. This information will be printed on the outside of the sensor. You must determine the correct frequency for your vehicle, either by consulting the service manual or removing the sensor.
How do I know if my van has TPMS?
To confirm if your vehicle has TPMS, turn the key to the “On” position without starting the engine. If you see a light on your dashboard that looks like the one below, you have TPMS. You can also check the owners manual for your vehicle for more information.
How much does it cost to fit TPMS?
TPMS Replacement Cost From £64.99 per wheel at the time of fitting to replace the whole complete TPMS sensor valve stem and components.
When to reset tire pressure sensor in Volkswagen?
1. Read out tire pressure sensor IDs before installation. 2. Switch TPMS to wheel set 2. 3. Enter needed specified tire pressures and sensor IDs into system. NOTE: Whenever a wheel is changed or replaced, or whenever vehicle has been loaded, the TPM system needs to be reset.
How to reset the tire pressure monitor system?
See Tire Pressure Monitor System Reset. When the low tire pressure warning light comes on, immediately check air pressure of all tires and adjust to the specified pressure. Reset TPM system. See Tire Pressure Monitor System Reset. If light is still on, there is a malfunction in the TPM system.
How to set tire pressure in Volkswagen TPMS?
1. Set the tire pressure of all wheels to specified pressure. 2. With vehicle stopped and parking brake applied, turn ignition switch to ON position. 3. Press SET button (located near gear shift) until an audio signal is heard. See Fig. 10. The signal confirms basic setting. 1. Set the tire pressure of all wheels to specified pressure. 2.
How to reset TPMS in Volkswagen Vas 5051b?
NOTE: If unapproved wheel/tire combinations are installed, a 2nd wheel set must be learned. To perform this procedure, Volkswagen VAS 5051B is required. 1. Read out tire pressure sensor IDs before installation. 2. Switch TPMS to wheel set 2. 3. Enter needed specified tire pressures and sensor IDs into system.