How do you reset the oil light on a 2012 Nissan Maxima?

How do you reset the oil light on a 2012 Nissan Maxima?

Oil Change Light Reset Nissan Maxima 2011 2012 2013 2014

1. Turn the ignition to the “RUN” position (press the “START/STOP” button once).
2. Press the square button to display “SETTINGS” mode.
3. Press the circle button to move to “MAINTENANCE”.
4. Select “ENGINE OIL” and follow the prompts. Repeat for “ENGINE OIL FILTER”.

How do you reset the oil light on a Nissan Maxima?

How To Reset Maintenance Oil Light on Nissan Maxima (2004-2021)

1. Turn on the ignition without starting the engine. Make sure your vehicle is stopped.
2. Go to MAINTENANCE menu by pressing the TRIP button repeatedly.
3. Scroll down and select ENGINE OIL.
4. You can reset or set the distance for service interval on this menu.

How do you reset the change oil light on a Nissan Maxima?

2015-2020 NISSAN MAXIMA OIL & FILTER SERVICE MAINTENANCE DUE RESET

1. Turn the ignition On. Don’t start the engine.
2. Press the RIGHT ARROW to navigate SETTINGS.
3. Inside SETTINGS MENU, Scroll to MAINTENANCE.
4. Under MAINTENANCE select OIL & FILTER.
5. Then Select RESET.
6. Then Select YES to confirm.
7. Turn Ignition OFF.

How to reset Nissan Maxima maintenance oil and filter light?

Press the BACK button on the control panel to go back to the previous screen Repeat steps 3-6 for Oil Filter and Tire (if the tires were rotated during service) Use center joystick to scroll down to Maintenance menu then press ENTER on the joystick to select

What kind of oil should I put in my Nissan Maxima?

There’s no single one-size-fits-all answer to this question because a lot can depend on the quirks of your particular car. A 10W-30 motor oil is probably preferable in most situations, but a lot depends on the vehicle’s oil consumption. If it uses one quart of 10W-30 per 3,500 miles and the engine sounds good, stay with the 10W-30.

Where is the maintenance button on a Nissan Maxima?

Use the INFO button to find the Maintenance option and press ENTER to select the option (some displays will have a MAINTENANCE button instead of an INFO button in which case you will only need to push the MAINTENANCE button to proceed to the next step)