How do you reset the computer on a club car?
Resetting the Club Car On board computer – reset the OBC Disconnect the Battery NEGATIVE (–) wire from the Battery Minus terminal on the battery pack. The reverse buzzer will sound and go off in about 30 seconds. Leave the cart like that for 5 min to cause the OBC to reset.
How do you troubleshoot an electric club car?
There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.
- Test the wall socket where you charge your cart.
- Expose your golf cart batteries.
- Test the batteries for voltage.
- Replace dead batteries.
- Expose the motor for inspection.
- Reset the motor.
- Test the cart.
Where is the reset button on club car motor?
It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.
How do you test a Club Car electric motor?
To properly test the motor, connect a fully charged 12-volt battery to the electric motor’s battery posts.
- Park the club car on a level surface and turn the key to the “off” position.
- Jack the rear of the club car up and place jack stands at the proper rear jacking points.
How to reset my club car golf cart OBC?
Easily Reset the Club Car Golf Cart OBC 1 Reconnecting the OBC into the system: 2 Key switch to off 3 Set forward/reverse switch to neutral 4 Put tow/run switch to tow 5 Reconnect the negative battery terminal from the battery pack
How do I change my club car controller?
Now you put tow run switch to run and set from a neutral position to reverse. Finally, you put key to switch it on. You have another option, and that is to replace your OBC with a new one.
Why is my 2003 club car not moving?
There does not seem to be any voltage getting to the solenoid. No other fixes done. He just replaced the two small lugs back to front. The original problem was that in forward the cart kept cutting out (there was a clicking sound then cart cuts out) but in reverse there was no problem.
How do you reset an electric golf cart?
On electric motors there are often reset buttons that act like mini circuit breakers. Generally, where the wires enter the unit a small little red button will be sticking out in that same vicinity. Find the button and push it back in. Test the cart. When the reset button has been pushed it, turn the cart on and gently push on the power pedal.
Easily Reset the Club Car Golf Cart OBC 1 Reconnecting the OBC into the system: 2 Key switch to off 3 Set forward/reverse switch to neutral 4 Put tow/run switch to tow 5 Reconnect the negative battery terminal from the battery pack
Now you put tow run switch to run and set from a neutral position to reverse. Finally, you put key to switch it on. You have another option, and that is to replace your OBC with a new one.
There does not seem to be any voltage getting to the solenoid. No other fixes done. He just replaced the two small lugs back to front. The original problem was that in forward the cart kept cutting out (there was a clicking sound then cart cuts out) but in reverse there was no problem.
On electric motors there are often reset buttons that act like mini circuit breakers. Generally, where the wires enter the unit a small little red button will be sticking out in that same vicinity. Find the button and push it back in. Test the cart. When the reset button has been pushed it, turn the cart on and gently push on the power pedal.