How do you reset the ABS light on a 2004 Honda Accord?
When the ABS indicator light goes out, release the brake pedal until the light comes on again and press on the brake pedal. Hold the pedal down until the ABS light goes out and release the pedal. The ABS light should blink twice to indicate that the code are erased.
Can you replace the ABS sensor on a Honda Accord?
Here’s how to replace the ABS sensor on a Honda Accord. This also applies to other Honda and Acura vehicles, such as the Acura TSX, TL, Civic, CRV, Element, Odyssey, etc. The ABS sensor is responsible for sending pulses from the wheel to the computer.
Why does my abs light come on when I clean my wheel sensor?
Some of those things are serious, but oftentimes it just means you need to clean the sensors. One or more dirty wheel sensors (all cars with anti-lock brakes have at least one) can cause the system to trigger the ABS light during the computer’s self-evaluation cycle.
How big is the ABS sensor on a Honda?
A good sensor will measure 450 mega ohms. The ABS light should come off once the sensor has been replaced. If not, use a scanner or pull the battery to reset the codes. Now you can finally have peace of mind that you have working anti-lock brakes on your Honda.
How to fault reset Honda ABS and VSA?
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
What causes an ABS sensor to short out?
Damaged ABS Sensor The ABS wheel sensor monitors the wheel rotation, controlled by its computer. This sensor works as a conjunction with the wheel stator attached to axle brake rotor, bearing hub or CV joint. With time, these sensors may short out as they are subject to vibration or road conditions. 3. Faulty ABS Computer Module
What to do if your Honda ABS light keeps coming on?
Turn the ignition switch off, remove the key and disconnect the jumper wire from the OBD connector. If the ABS light comes back on again after step #7, do the entire procedure again, it may take a few tries to get the fault codes to clear.
How long does it take for ABS sensor to reset?
It may take up to a few days for the system to reanalyze itself and reset fully.